Specifications

XD10 Cinema Media Player, Installation and Operating Guide Version 1.0
If levels sound unbalanced, check the cinema processor’s output levels. Then be sure that the
XD10 output of 300mV RMS on all channels matches the input reference level of your cinema
processor.
The XD10 MUST match the cinema processor’s input reference level. (The input reference
level of
two-projector theater, repeat this procedure for Projector 2.
eck Automatic Fail-Safe (Default) Operation
your cinema processor should be indicated in its manual or consult the manufacturer.)
7. If a
3.4.2. Ch
fail for any reason, the system
1. t
nd keep it there for at least six seconds.
2.
during dialogue scenes.
This procedure will verify that, should the DTS timecode reader
will automatically switch to optical sound format.
While the demo film is running, block the timecode at the reader or unplug the 9-pin connector a
the reader.
To block the timecode reader, insert a business card between the film and the lens of the timecode
reader head a
Verify that after 4 to 5 seconds of not seeing timecode, the DTS-XD10 switches to the SR optical
sound format.
There should not be a dramatic sound level difference when the cinema processor switches from
digital to analog
If there is a dramatic difference, check the cinema processor’s levels (A- and B-chains) first and
then test again.
Remember, the XD10 output level must match the cinema processor’s input reference level.
mat after about two seconds.
3. Now, restore timecode and XD10 should automatically switch the cinema processor to the digital
for
4. If a two-projector theater, repeat this procedure for Projector 2.
Calibration and Setup Document #: 9301E692001.0
3-5