Specifications

XD10 Cinema Media Player, Installation and Operating Guide Version 1.0
5.4. Inside the DTS XD10
Refer to Figures 5-1 and 5-2 (pages 5-5 and 5-6) for location of components within the XD10 chassis.
5.4.1. Timecode Board
The Timecode board (E622) contains the timecode head offset information and these connectors:
• the serial connection to the Front Panel containing the LCD display and 7 system status LEDs
• a 9-pin timecode cable output D-type connector
• two auxiliary audio outputs, RCA-type connectors
• a 7 pin Phoenix connector and DB25F for Cinema automation control
The OFFSET is set in the software according to the timecode reader location. This setting is different
depending on type of projector or location of the timecode reader. See Timecode Reader Sync
Adjustment, in chapter 3, for instructions to determine the OFFSET setting.
The status LEDs on the front panel include:
Table 1. Front Panel LED Indicators
LED Color Indication
DTS PLAYBACK Blue Outgoing signal / digital signal
TIMECODE Green Incoming Timecode data
VIDEO Green Transmitting Intermission program, or
other audio/video material
NARRATION Green Outputting narration
SERIAL Green Serial data output / Rear Window
captions
CSP TEXT Green CSS subtitles
CSP LAMP
FAULT
Red If flashing, replace CSS projector lamp.
Solid light indicates lamp failure.
A circuit breaker protects the power going to the Timecode Reader head (through the 9-pin connector)
against short circuits. The breaker is self-resetting so replacement is unnecessary.
The 9-pin connector (accessed on the DTS-XD10 rear panel) is used to connect the timecode cable to the
timecode reader on the projector.
5.4.2. Power Supply
This unit supplies power to the DTS-XD10 Player. This supply is switchable between 110 VAC and 220
VAC and adjusts automatically.
The cooling fan in the power supply should be rotating when power is applied.
To prevent dirt from being pulled into the DVD/CD-ROM drives, do not block the ventilation
holes at the side of the DTS-XD10 player.
5.4.3. DVD/CD-ROM Drives
There are two DVD/CD-ROM drives in the DTS-XD10. The two are identical, except for the way
jumpers are installed. The top drive (A) is jumpered to be “master” and the bottom drive (B) is jumpered
to be “slave”.
Maintenance and Troubleshooting Document #: 9301E692001.0
5-4