User manual

4- Voltage and frequency
The XM2500 E.B.(ELECTRONIC BALLAST) can operate at 190-245 VOLT 50 or 60 Hz.
5- Installation
XM2500 may be either floor or ceiling mounted.
For floor mounting installations, the XM2500 is supplied with four rubber mounting feet on the
base.
For ceiling mounted installations, we reccomend the use of appropriate clamps to fix the unit to
the mounting surface.
The supporting structure from which the unit is hung should be capable of bearing the weight of
the unit, as should any clamps used to hang it. The structure should also be sufficiently rigid so as
not to move or shake whilst the XM2500 is moving.
Eight quarter-turn fast locks placed on the base of the units allow - by using the two Omega
Clamps provided in the box - to fix the unit in any position.
.
Safety chain
We recommend the use of a safety cable or chain connected to the XM2500 and to the suspension
truss in order to avoid the fixture accidental fall, should the main fixing point fail. Make sure
that the iron cable or chain can bear the weight of the entire unit.
You may attach the safety chain to the two holes (A) located on the base of the fixture, as shown
in the picture below.
Protection against liquids
The projector contains electric and electronic components which should under no circumstances
come into contact with oil, water or any other liquid. The proper unit functioning would be
compromised should this occur.
A
ARC 1200
7
XM 2500 SPOT
quarter turn
fast locks
quarter turn
fast locks