User`s manual

15- HIDDEN MENU
ARC 1200
XR300 BEAM
25
XR300 BEAM BF (Cod. 03.MB003.L) • Electromagnetic ballast
For technical personnel only.
To operate this menu:
-Connect the projector to the DMX controller (DMX SIGNAL MUST BE CORRECTLY RECEIVED)
- Reset the XR300 BEAM (reset from the MENU, not from the DMX controller!).
- While reset is running, press the MENU and ENTER keys at the same time.
Electronic calibration of the motors.
Reset EEPROM (Reset all settings. ATTENTION: by pressing this key you must
repeat all previous calibrations)
Exit from hidden menu.
Up-DownENTER
PAN ALIGNMENT
To align pan
ENTER
Up-DownENTER
TILT ALIGNMENT
To align tilt
ENTER
Up-Down
Up-Down
ENTER
Up-DownENTERUp-Down
SHUTTER ALIGNMENT
To align shutter
ENTER
Up-DownENTERUp-Down
GOBO WHEEL ALIGNMENT
To align gobo wheel
ENTER
Up-DownENTER
Up-Down
GOBO ROTATION ALIGNMENT
To align gobo ROTATION
ENTER
Up-DownENTERUp-Down
COLOR ALIGNMENT
To align color wheel
ENTER
16- PAN & TILT SPEED (default: 4)
17- FAN SPEED ( default: 5)
You can set the PAN and TILT motors at high speed on your XR300 BEAM.
Press menu until you see PAN TILT SPEED.
Press ENTER and select a speed with UP-DOWN (there are 4 speeds). Confirm by pressing ENTER.
Fan speed regulation makes it possible to reduce fan noise. However, the ambient temperature must be
less than 35° C.