User guide

First Time Installation

After all the connections have been made

properly switch on your TV, make sure the

receiver is connected to the mains. If you are

using the receiver for the rst time or restored

to factory default the Weclome Screen will be

displayed and then press the OK button to auto

scan.

When the receiver has nished scanning,

all active channels found will be stored

automatically. The rst found channel will be

viewed. If you want to stop scanning, press the EXIT button to exit and the channels already found

will be stored.

Switch Program

1. Press the numeric buttons (0~9) on the remote control to select the channel you want.

2. Press the P+/- buttons on the remote control or the front panel to change the available channels

up and down.

3. Press the BACK button to view the previous channel selected.

Volume Control

• Press the V+/- button on the remote control

or front panel to adjust the volume and the

volume bar will be displayed.

• Press the button to switch the sound o. If you want to cancel this function, you can press the

button again or press the V+/–.

Text

• Press the TEXT button to enter MHEG if MHEG is transmitted.

• Press the TEXT button again or press the EXIT button to exit the MHEG (TV mode).