Use and Care Manual

Installation Instructions:
Flip up the back seat.
Thread the nylon straps through the seat belt brackets/bottom of the seat belt under
the rear seat (on top of the ledge) by sliding each strap through the back side of the
brackets/seat belts so the buckle ends up on top.
Position the DU-HA under the rear seat with cut out slots facing towards the truck bed.
Thread the nylon straps through the slots in the back of the DU-HA.
Secure each strap by threading the strap up through the bottom of the back slot of the
buckle and down through the front slot of the buckle. Tighten. The nylon straps will help
secure the DU-HA in the truck.
Install the dividers by sliding them into the channel slots inside the DU-HA.
Install the foam organizer/gun racks and plastic stiffeners by putting one stiffener on
each side of the foam piece and sliding them into the pre-cut slots in the dividers,
making sure the high side of each piece faces towards the front (as shown).
Safety Instructions:
Warning: Seat bottom must be latched down at all times while vehicle is moving. Make sure the
DU-HA is secured in the vehicle according to installation instructions. Do not store explosives
or hazardous materials in the DU-HA. Do not place loaded guns in the DU-HA.
For further instructions refer to truck owners manual or contact DU-HA, Inc.
Troubleshooting:
If the seat doesn’t want to come all the way down, try the
following: 1) Check to make sure both the DU-HA and the
organizer/gun racks are facing the correct direction (slots facing
back/high sides forward). 2) On the back rest of the seat, behind
each head rest and down a few inches, there are two brackets,
each containing a rubber grommet. Lube these brackets using
WD-40 or another form of spray lubricant. (Note: The bottom
seat must ipped up to access these brackets.)
99–07 Chevrolet & GMC Silverado/Sierra Extended Cab (Classic)
Underseat Storage
Installation Instructions
DU-HA, Inc. // website: www.du-ha.com // phone: [phone].DUHA (3842) // fax: [phone] // 306 Saint Andrews Street South, Fergus Falls, MN 56537
1
2
3
4
5
6
7
A
B
D
E
C
Fits DU-HA Part Numbers
Part Description Qty
A DU-HA Storage Unit 1
B Divider 2
C Foam Organizer / Gun Rack 2
D Plastic Stiffener 4
E Nylon Strap with Buckle 2
10001
10002
10003
DIVIDER – 10001
Photo shows two models of seat belt
brackets, straps should loop through.
Ribs on buckle should face up. Thread
strap through buckle as shown.
2
3
6
7
4
5
1