Use and Care Manual

Installation Instructions:
Flip up the back seats.
Thread the nylon straps through the seat belt brackets (seat belt brackets are located
at the bottom of the seat belt, under the rear seat, on top of the ledge) by sliding each
strap through the backside of the brackets/seat belts so the buckle ends up on top.
Under the back seats you will have a jack tools bag. Turn the wing nut on the jack tools
bag counterclockwise and remove the wingnut and metal bracket.
Remove jack tools bag and set aside.
Position the DU-HA under the back seats with the cut out slots facing towards the truck
bed. Make sure the seat belt is not under the DU-HA. If it is, simply pull it out from
underneath the DU-HA and set it closer towards the back of the cab.
Thread the nylon straps through the slots in the back of the DU-HA.
Secure each strap by threading the strap up through the bottom of the back slot of the
buckle and down through the front slot of the buckle. Tighten. The nylon straps help
secure the DU-HA in the truck.
Install the foam organizer/gun racks with plastic stiffeners by sliding them into the pre-cut
channel slots in the DU-HA, if desired.
Set jack tools bag on the ledge behind the DU-HA or inside the DU-HA, if desired.
Safety Instructions:
Warning: Seat bottom must be down at all
times while vehicle is moving. Make sure the DU-HA
is secured in the vehicle according to installation
instructions. Do not store explosives or hazardous
materials in the DU-HA. Do not place loaded guns
in the DU-HA.
For further instructions refer to truck
owners manual or contact DU-HA, Inc.
07-13 Chevrolet & GMC Silverado/Sierra Extended Cab
Underseat Storage
Installation Instructions
DU-HA, Inc. // website: www.du-ha.com // phone: 1.866.306.DUHA (3842) // fax: 1.218.998.4013 // 306 Saint Andrews Street South, Fergus Falls, MN 56537
1
2
3
4
5
6
7
8
A
B
D
C
Fits DU-HA Part Numbers
Part Description Qty
A DU-HA Storage Unit 1
B Foam Organizer / Gun Rack 2
C Plastic Stiffener 2
D Nylon Strap with Buckle 2
10045
10046
10047
Ribs on buckle should face up. Thread
strap through buckle as shown.
2
1
4 5
6
7
DRIVER SIDE
DRIVER SIDE
PASSENGER SIDE
PASSENGER SIDE
3
DIVIDER – 10045

Summary of content (2 pages)