Use and Care Manual

Materials Needed:
// Pliers
// Screwdriver
// 18mm socket or T-55 Torx (Depending on the year of your truck.)
Installation Instructions:
Flip up the bottoms of the back seats.
Loosen jack from under passenger side back seat. Slide jack rearward and retighten.
Remove jack handle bag from oor of cab. (Note: Some models do not have jack handle bag under
the back seat. In these models install the DU-HA using the existing seat bracket bolt - shown in Step 4.)
Remove rectangular metal bracket from jack handle bolt using a pliers to depress the
plastic tabs that hold the metal bracket to the bolt. Pry wing nut off of metal bracket
using screwdriver. (Note: You will use the wing nut to secure the DU-HA. You won’t need metal bracket.)
Using an 18mm socket or T-55 Torx (depending on the year of your truck), remove the
bolt (or nut) from the center seat bracket.
Set the DU-HA under the back seat (text facing front) and match the pre-drilled holes in
the DU-HA with the holes in oor. Re-install the bolt (or nut). Do not over-tighten. Then put
the wing nut bolt (if your model has one) into the other hole and tighten.
Place jack handles behind the DU-HA on passenger side or inside the DU-HA.
Install foam organizer/gun racks with plastic stiffeners by sliding them into the slots in
the DU-HA (as pictured).
Safety Instructions:
Warning: Seat bottom must be latched down at all
times while vehicle is moving. Make sure the DU-HA
is secured in the vehicle according to installation
instructions. Do not store explosives or
hazardous materials in the DU-HA.
Do not place loaded guns in the DU-HA.
For further instructions refer to truck
owners manual or contact DU-HA, Inc.
00-14 Ford F-250 thru F-550 Super Duty Supercab
Underseat Storage
Installation Instructions
DU-HA, Inc. // website: www.du-ha.com // phone: [phone].DUHA (3842) // fax: [phone] // 306 Saint Andrews Street South, Fergus Falls, MN 56537
1
2
3
4
5
6
7
A
B
C
Fits DU-HA Part Numbers
Part Description Qty
A DU-HA Storage Unit 1
B Foam Organizer / Gun Rack 2
C Plastic Stiffener 2
20093 20014
20082 20015
20083 20016
20031
DIVIDER – 20014
2
This is how the DU-HA should look
installed under the back seat.
3
4
Helpful Hint:
The jack can also be stored underneath the
truck, on top of the spare tire, to free up
space in the DU-HA.
First wrap the jack in a plastic bag or cloth,
to keep it from getting dirty. Then, lower the
spare tire (per instructions on jack tools) from
under the truck and set the jack on top, as
pictured. When nished, reel tire back up.
5
7