Owners manual

Installation Instructions:
Extendable Handle
The extendable handle (J) on the end of the Squad Box extends out for easier transporting. Just grab the handle
next to the foam grip and pull out until it stops. Slide back in when not in use.
Pull Strap
If desired, attach the Pull Strap (B) to the extendable handle (J) on the end of the DU-HA Squad Box (A) by
wrapping the Pull Strap around the handle and pulling the Pull Strap through its loop on one end. This makes it
easeir to pull out the extendable handle by just pulling on the pull strap. The strap can also be attached to the
other small handles handles.
Foam Organizer / Gun Rack / Stiffeners
(1) Sandwich each Foam Organizer / Gun Rack (C) in between two Plastic Stiffeners (D).
(2) Place each Foam Organizer / Gun Rack / Stiffener assembly into the channel slots in the side walls of the
Squad Box (A), facing opposing directions. There are 3 positions on each end.
Note: You may have to bend the assembly to get it into place or put each piece in separately.
(Hint – The stock of a gun should rest in a large groove and the barrel rests in a small groove.)
Dividers
Slide one Divider (E) over each Foam Organizer / Gun Rack / Stiffener assembly, with the square
corners to the middle, interlocking the center grooves. Dividers should rest on the Squad Box bottom.
Velcro Straps
To secure guns in the Squad Box, loop each Velcro Strap (F) through the holes in the top of the Foam Organizer /
Gun Rack / Stiffener assembly. Wrap the Velcro Strap around the gun, then attach the Velcro Strap to itself and
make sure it is securely fastened.
(Note: Proper use of the Velcro Straps helps prevent guns from bouncing around on rough terrain.)
Trays
Two Trays (G) can fi t in the Squad Box at one time. Insert Tray Dividers (H) in desired slots of the Trays to
organize cargo.
Wheel Brake
There is one wheel brake (I) on the Squad Box on the opposite end of the slide out handle, activate the brake by
pressing down on the lever and lift up to release. It can be adjusted by loosening the bolts and repositioning the
brake and re-tightening the bolts, you will need to remove the wheel assembly.
Center Brace
The Center Brace (K) must be in position at all times, ulness you are loading or
unloading items in the Squad Box. The Brace can be removed from both inserts,
as shown in
8a or it can be removed from one end and rotated 90° as shown in 8b.
Optional Squad Box Slide Bracket
The Squad Box Slide Bracket is available as an option to ease access to cargo
and secure the Squad Box for transportation in a vehicle. (Part # 70700.)
Safety Instructions:
Warning: 75 LBS CAPACITY – DO NOT EXCEED 75 POUNDS OF CARGO IN THE
SQUAD BOX. CAUTION – Squad Box must be secured in vehicle at all times with the
lid latched while transporting. Do not store explosives or hazardous materials in the
Squad Box. Do not place loaded guns in the Squad Box. For further instructions refer
to the vehicle owner’s manual or contact DU-HA, Inc.
DU-HA Squad Box — Portable Storage
Installation Instructions
DU-HA, Inc. // website: www.du-ha.com // phone: [phone].DUHA (3842) // fax: [phone] // 306 Saint Andrews Street South, Fergus Falls, MN 56537
Rev-A
1
2
3
4
5
6
A
B
C
F
D
I
E
G
H
Part Description Qty
A DU-HA Squad Box 1
B Pull Strap 1
C Foam Organizer / Gun Rack 2
D Plastic Stiffener 4
E Divider 2
F Velcro Strap 8
G Tray 2
H Tray Divider 8
I Wheel Brake 1
J Extendable Handle 1
K Center Brace 1
2
1
7
3
4
5
6
J
I
G
Fits DU-HA Part Numbers
70600 & 70670 - Standard Latch
70601 & 70671 - Internal Latch
DIVIDER – 70600
SQUAD BOX
7
J
8
K
D
C
8
8a 8b
B
E
F
H