XHD7714 INSTALLATION/OWNER'S MANUAL CD Receiver with Detachable Face
XHD7714 INSTALLATION Preparation Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. Consult a qualified technician for instructions. • Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration. Getting Started • Remove trim ring from unit, • Remove 2 transit screws located on top of the unit.
XHD7714 INSTALLATION Wiring Diagram RCA Connections Right Channel (Red) Left Channel (White) REAR SUBWOOFER FRONT FRONT SUB/W L-CH R-CH REMOTE IN Antenna Connector Steering Wheel Interface Input (PAC SWI-PS required) FUSE When replacing the fuse, make sure new fuse is the correct type and amperage. Using an incorrect fuse could damage the radio. The XHD7714 uses one 10 amp ATM fuse located beside the wiring connector.
XHD7714 OPERATION Control Locations - Receiver 1 2 3 22 21 20 19 18 4 5 17 16 6 7 15 14 1 Open 12 USB Port 2 Talk 13 Preset 6/Folder Up 3 Mute/End Call 14 Preset 5/Folder Down 4 Tune/Track Down 15 Display 5 Power ( )/Select 16 Volume 6 Tune/Track Up 17 Mode/EQ 7 Preset 1/Repeat 18 Bluetooth Microphone 8 Preset 3/Intro 19 Band/ESC 9 Preset 2/Random 20 Audio/Menu 10 Preset 4/Play/Pause 21 Scan/HD Seek 11 Auxiliary Input 22 Tag 9 8 13 10 11 12 The XH
XHD7714 OPERATION Control Locations - Remote 1 2 3 4 5 21 6 20 7 19 8 18 9 10 17 11 16 12 15 13 14 1 Mode/EQ 12 Key 9 2 Power( )/Select 13 Mute/End Call 3 Volume Up 14 Display/Key 0 4 Audio/Menu 15 Talk 5 Tune/Track Up 16 Key 8/Tag 6 Volume Down 17 Key 7 7 Scan/PS/# Key 18 Preset 4/Play/Pause 8 Preset 3/Intro 19 Preset 1/Repeat 9 Preset 2/Random 20 Band/ESC/* Key 10 Preset 6/Folder Up 21 Tune/Track Down 11 Preset 5/Folder Down 5
XHD7714 OPERATION General Operation Faceplate Removal Semi-Permanent Faceplate Installation Power On/Off Mode Press OPEN to fold down the front panel, then pull away from the bottom to remove. To re-install, slide in the right side of the bottom of the front panel first, then snap the left side into place and fold up. Remove trim ring and install two supplied #1 x 7/32” Phillips head screws through both of mounting frame into faceplate. Press or any other button to turn the unit on.
XHD7714 OPERATION General Operation Setup Menu Press and hold AUD•MENU for more than 3 seconds to access the setup menu, then press AUD•MENU to cycle through menu options. When desired option appears in the display, rotate the volume knob left/right to adjust or activate the desired function. Press ESC to exit the menu at any time. Setup Menu Menu Function Options Auto Station Store AUTO STORE Press SELECT to save 6 strong stations in the current band. Note: This option only appears in Tuner mode.
XHD7714 OPERATION General Operation Escape Audio Press ESC to exit any menu adjustment mode. Press AUD•MENU momentarily to select between Volume (default), Bass, Treble, Balance, Fader, Subwoofer and Source Volume Level. VOLUME Bass Treble BASS TREBLE BALANCE FADER SUBWOOFER SOURCE LEVEL Press AUD•MENU until BASS appears, then press SELECT to confirm. Rotate volume left/right to adjust (-6 minimum / +6 maximum). Press AUD•MENU until TREBLE appears, then press SELECT to confirm.
XHD7714 OPERATION HD Radio™ AM/FM Tuner Operation Analog and Digital Tuning Seek Tuning The following tuning functions will access both analog and digital stations. Refer to the HD SEEK mode section on page 10 for instructions on tuning to only digital stations. nn ll Press TUNE or TUNE for more than one second to seek the next strong station. Hold to advance quickly. When an HD Radio station is selected, an HD Radio logo will begin to flash on the display.
XHD7714 OPERATION HD Radio™ AM/FM Tuner Operation Display When the unit is tuned to an analog station, press DISP to toggle the display between the following options: (LINE 1) (LINE 2) FREQUENCY BAND/PRESET FREQUENCY CLOCK When the unit is tuned to an HD Radio station, press DISP to toggle the display between the following options: (LINE 1) (LINE 2) FREQUENCY CLOCK ARTIST SONG TITLE PROGRAM TYPE STATION NAME When information is unavailable, "NO DATA" appears in the display.
XHD7714 OPERATION iTunes® Tagging Overview Tagging Music Step 1 The iTunes Tagging feature of the XHD7714 allows the user to "Tag" songs that are playing on HD Radio™ stations and enables them to be purchased later through iTunes®. With the touch of a button the unit will remember the title and artist song information, and then transfer that information to your iPod device the next time you connect it to the XHD7714 using the supplied 2-wire cable.
XHD7714 OPERATION iTunes® Tagging Below is a list of messages that may be displayed when using the iTunes Tagging feature with an explanation of the message. Description Displayed Message CHECK iPod VER SENDING TAGS iPod FULL TRANSFER FAILED ALREADY TAGGED MEMORY FULL CONNECT iPod NO TAG INFO TAGGING FAILED NO TAGS STORED There is a compatibility issue. Check the list of compatible iPod devices below. If the attached iPod device is compatible, update the firmware to the latest version using iTunes.
XHD7714 OPERATION CD Player Operation Insert CD Press OPEN to fold down the front panel and expose the CD slot. Then with the label facing up, insert a standard size CD into the CD slot. Eject CD Press OPEN to fold down the front panel and expose the button. Press to eject the CD. The unit will change to previous mode of operation (AM/FM, USB, operation of iPod, AUX or Bluetooth). If the disc is not removed within 10 seconds, the unit will reload the disc.
XHD7714 OPERATION CD Player Operation - MP3/WMA Files Playing an MP3/WMA Disc Displaying Information When an MP3/WMA encoded disc is first inserted, “READING” will appear in the display. Depending on the number of files and folders, this may take several seconds.
XHD7714 OPERATION CD Player Operation - MP3/WMA Files Folder/File Search Mode (step 1) Press SELECT to enter the folder/file search mode. The unit will read the CD, and a list of folders and files from the CD will be displayed, starting from the current folder. • The current folder name will be displayed on the top line. • The list of folders and files contained in the current directory will be on the bottom line of the display.
XHD7714 OPERATION CD Player Operation - MP3/WMA Files Folder Access Press to select the previous folder. Press to select the next folder. Note: Folder access is only available on MP3/WMA discs recorded with more than one folder. Repeat Press RPT to enter the Repeat menu, then turn the volume knob to select one of the following options: • ALL - Continuously repeats the entire disc. • TRACK - Continuously repeats selected track. • FOLDER - Continuously repeats all files in selected folder.
XHD7714 OPERATION CD Player Operation - MP3/WMA Files Media Compatibility The following types of discs/files are compatible: • CD-ROM (ISO), CD-R, CD-RW • CD-DA • MP3 data • WMA data The following types of discs/files are not compatible: • WMA files that are protected by DRM (Digital Rights Management).
XHD7714 OPERATION CD Player Operation - MP3/WMA Files Additional MP3/WMA Information An internal buffer provides ESP (Electronic Skip Protection) to virtually eliminate skipping. When playing a disc recorded with regular audio files (CD-DA or .WAV) and MP3/WMA files, the unit will play the MP3/WMA files only. Only MP3 files with filename extension (.mp3) can be played. Only WMA files with filename extension (.wma) can be played.
XHD7714 OPERATION USB Operation - MP3/WMA Files (Optional) Connecting a USB Device (sold separately) Play MP3/WMA files from most mass storage devices by connecting them to the XHD7714's USB port. Playing Music When a USB device is first connected, play will begin automatically, and “READING” will appear momentarily in the display. Depending on the number of files and folders, this may take several seconds.
XHD7714 OPERATION USB Operation - MP3/WMA Files (Optional) Repeat Press RPT to enter the Repeat menu, then turn the volume knob to select one of the following options: • ALL - Continuously repeats the entire disc. • TRACK - Continuously repeats selected track. • FOLDER - Continuously repeats all files in selected folder. Random Press RDM to enter the Random menu, then turn the volume knob to select one of the following options: • OFF - Cancels the RDM function.
XHD7714 OPERATION USB Operation - MP3/WMA Files (Optional) Character Support (MP3 ID3 tag v1.0 - 1.1) Maximum character display information • Track name – 30 character maximum • Folder name – 30 character maximum • *Song title – 30 character maximum • *Artist name – 30 character maximum Character Support (MP3 ID3 tag v2.0 - 2.
XHD7714 OPERATION USB Operation - MP3/WMA Files (Optional) Additional MP3/WMA Information Sampling Frequency Rates MP3 WMA Transfer Bit rates MP3 WMA Only MP3 files with filename extension (.mp3) can be played. Only WMA files with filename extension (.wma) can be played. Do not attempt to play non-MP3/WMA files with the MP3/WMA extension.
XHD7714 OPERATION Operation of iPod Connecting an iPod Device (Not Included) Use the included 2-wire cable to connect an iPod device to the XHD7714. Once connected, press MODE until "iPod" appears in the display. Playback will begin automatically. If a song is playing on the iPod device before it is connected, it will continue to play. Note: Both the USB and auxiliary input connections must be made when connecting the 2-wire cable.
XHD7714 OPERATION Operation of iPod Song Select Fast Forward and Reverse Pause Repeat Random to skip to the beginning of the next song. ll to the beginning of the current song. nnnnto return again skips to the beginning of the previous Press and hold ll or nn to fast forward or reverse a song. Press Press Pressing song. Press Press temporarily stop playback. ll// IIII toagain to resume playback.
XHD7714 OPERATION Bluetooth® Operation Overview The XHD7714 supports the HFP (hands-free profile), A2DP (advanced audio distribution profile) and AVRCP (audio video remote control profile). Preparation Before you can use a mobile device with this head unit, it must be connected and authenticated - commonly referred to as "pairing" a device. Please make sure that Bluetooth is activated on your mobile device before you begin the pairing process.
XHD7714 OPERATION Bluetooth® Operation Function Description Press once. "Enter Number" will be shown, then An "_" will appear on the display. Input the desired phone number using the 0-9, *, # buttons on the Making a Phone Call remote control. Press to begin dialing. A phone call may also be placed from your mobile device using the keypad, phone book or speed dial. When a call is placed from a mobile device, “DIALING” will appear on the head unit display.
XHD7714 OPERATION Bluetooth® Settings Description Function To enter last number dialing mode, press , then press a second time. The head unit will display "LASTCALL MENU." Press DISP to cycle through the received, dialed or missed call Last Number Dialing categories. Rotate the volume knob to cycle through the last 5 calls in the selected category. Press to begin dialing the selected number. “DIALING” will appear on the head unit display.
XHD7714 OPERATION Bluetooth® Operation Bluetooth Streaming Audio Operation (AV MODE) The XHD7714 supports A2DP (advanced audio distribution profile) wireless streaming audio from your Bluetooth mobile device directly to your head unit. You can also control your music from the front panel of the head unit using AVRCP (audio video remote control profile). Notes: • To stream music to your head unit, your mobile device must support A2DP and AVRCP Bluetooth profiles.
XHD7714 OPERATION Limited One Year Warranty This warranty gives you specific legal rights. You may also have other rights which vary from state to state. Dual Electronics Corp. warrants this product to the original purchaser to be free from defects in material and workmanship for a period of one year from the date of the original purchase. Dual Electronics Corp.
XHD7714 OPERATION Troubleshooting - General Problem Action Yellow wire not connected or incorrect voltage Red wire not connected or incorrect voltage Check connections for proper voltage (11~16VDC) Black wire not connected Check connection to ground Fuse blown Replace fuse Speaker wires not connected Check connections at speakers One or more speaker wires touching each other or touching chassis ground Insulate all bare speaker wires from each other and chassis ground Yellow or red wire touching
XHD7714 OPERATION FCC Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Specifications CD Player Frequency response: 10Hz-20kHz Channel separation @ 1kHz: >65dB D/A converter: 1 Bit FM Tuner Tuning range: 87.5MHz-107.9MHz Usable sensitivity: 8.5dBf 50dB quieting sensitivity: 10dBf Stereo separation @ 1kHz: 40dB Frequency response: 30Hz-13kHz AM Tuner Tuning range: 530kHz-1710kHz Usable sensitivity: 22uV Frequency response: 30Hz-2.