Use And Care Manual

MAINTENANCE

• When the blade is not in use, it should be stored in its original sheath, well

cleaned and coated with an anrust agent.

LUBRICATION

• All of the bearings in this tool are lubricated with a sucient amount of high-

grade lubricant for the life of the tool under normal operang condions.

Therefore, no further lubricaon is required.

DOUBLE INSULATION

• Double insulaon is a concept in safety in electric power tools, which elimi-

nates the need for the standard 3-wire ground power cord. All exposed metal

parts are isolated from the internal motor components with protecng insula-

on. Double insulated power tools do not need to be grounded.

EXTENSION CORDS

• The use of any extension cord will cause some loss of power. To keep the loss

at a minimum and to prevent overheang, use an extension cord that is heavy

enough to carry the current that the tool will draw.

BLADE MAINTENANCE

• Don’t use any blades other than the DUALSAW™ CS 450 blades specially de-

signed for this tool. Other blades do not match the mounng hardware and

will cause loss of control.

• Do not use dull or damaged blades. Unsharpened or improperly set blades

produce narrow kerf causing excessive fricon, blade binding and kickback.

• Keep the blades clean, sharp and properly set. Using a dull blade will place

a heavy load on your saw and increases the danger of kickback. Keep extra

blades on hand, so sharp blades are always available.

• Gum and wood pitch hardened on your blade will slow your saw down. Use

gum and pitch remover, hot water or degreaser to remove these accumula-

ons. DO NOT use gasoline.

• Don’t aempt to operate saw with only one blade. Kickback will occur and

send the saw toward you resulng in serious injury.

WARNING!

When servicing, use only identical replacement parts. Use of other

parts may create a hazard or cause product damage.

Contact customer service at 1-855-382-5729 for information on how

to obtain replacement parts from an authorized service facility.

DUALSAW CS450 MANUAL 4_30_13.indd 20 7/8/13 3:00 PM