User's Manual

XDMAR6720 OPERATION

Bluetooth

Operation

MostBluetoothdevicessupporttheauto-connectfeature,andwillconnectautomaticallyif

thedeviceisinrangewhentheXDMAR6720ispowered-on.Ifyourdevicewaspreviously

pairedbutdoesnotconnect,usetheseinstructionsbelow.Somedevicesrequire

authorizationtoallowtheautoconnectfeature.

•IfyourmostrecentlyconnectedBluetoothdevicebecomesdisconnectedordoesnot

reconnect,press fromBluetoothmodetoreconnectyourmobiledevice.

•Toconnectapreviouslypaireddevicethatwasnotrecentlyconnected:

1)Ifapplicable,pressandhold todisconnectanyconnectedmobiledevices.

2)FromBluetoothmode,pressSELECT."PairedDevices"willappearontheLCD.

3)Turnthevolumeknobtocyclethroughthelistofdevices.

4)PressSELECT or toconnecttothedesireddevice.Itmustbeinrangetoconnect.

Note:IftheAuto ConnectsetupmenusettingissettoOFF,youmustpress toconnect

youdeviceafterpairing,andeachtimetheXDMAR6720ispowered-on.

Pressandhold for3secondstodisconnectaconnecteddevice.Thedevicewillremain

pairedandappearinthePAIREDDEVICESmenu,butnotbeconnected.

BeforeyoucanuseaBluetoothdevice,itmustbepairedand

connected.MakesurethatBluetoothisactivatedonyour

devicebeforeyoubeginthepairingprocess.

TheXDMAR6720broadcaststhepairingsignalconstantly

whennodevicesarecurrentlyconnected.Completethe

pairingsequencefromyourBluetoothdevice.Refertothe

owner'smanualforyourdeviceformoredetails.

The device name is "DUAL BT"

The Bluetooth passcode "1234"

Note:TheXDMAR6720canbeinanymodeofoperation

whenpairingisperformed.

Ifadeviceiscurrentlyconnected,pressandhold to

disconnectthecurrentdevicebeforeanewdevicecanbe

paired.Thenbeginthepairingsequencefromthenew

Bluetoothdevice.

Preparation

Pairing a New Device

Pairing Additional Devices

Pairing a Device

(Re)Connecting a Paired Device

Disconnecting a Device