LU47PW-LU47PB INSTALLATION/OWNER’S MANUAL Indoor/Outdoor 3-Way Dynamic Loudspeakers ®
® LU47PW-LU47PB INTRODUCTION Introduction Introduction The LU47 series speakers are designed as multi-purpose speaker and will deliver accurate high fidelity sound in exterior or interior environments. Weather-resistant design and construction provide optimum durability for permanent or temporary outdoor use. Both models are available in black or white. For simplicity, we will call your AV receiver or amplifier the “receiver.
® LU47PW-LU47PB PLACEMENT Speaker Placement Mounting Placement Ifmountingisdesired,mountingbothspeakersona commonsolidsurfacefacingthelisteningareawillprovide thebestaudioresults.DoNOTmountspeakersonwall surfacesthathavehazardsconcealedbehindthem,such aselectricalwiresorplumbing.Alwaysmountspeakeron surfacesthataresturdyenoughtosupportthespeakers’ weight,andmakesuretheycannotfallorcauseinjury.
® LU47PW-LU47PB INSTALLATION Placement & Mounting Speakers The LU47 series speakers have been tested for environmental usage and are weather resistant, but not waterproof. Occasional moisture will not affect performance. The speakers should be allowed to ventilate and dry after water exposure. The speakers can be placed permanently outdoors for year-round enjoyment. To maximize speaker life, position in areas protected from the elements, such as the underside of eaves and overhangs.
® LU47PW-LU47PB CONNECTION Connecting Speakers Connecting Your Speakers Speaker Wire -Typical speaker wire has a pair of separate speaker wires with insulating jackets that are molded together. Dual recommends the use of two conductor 18gauge speaker wire to connect your speakers to your receiver. Measure enough wire to reach from your receiver to each speaker plus additional length to allow moving the speakers or receiver without having to disconnect the wires.
® LU47PW-LU47PB CONNECTION & TROUBLESHOOTING Connecting Speakers Your Speakers The speaker wires must be inserted into the connector and tightened properly to the speaker inputs. Do not over-tighten. Do not allow the positive and negative speaker wire from the receiver to make contact, as this will cause a short. Banana style connectors may also be used on the LU47PB.
® LU47PW-LU47PB SPECIFICATIONS Specifications Specifications Frequency Response 100 Hz-20kHz Woofer 4" (100mm) Polyelite PVA Surround Midrange 40mm polypropylene Tweeter 20mm Piezo Dome Sensitivity 85.5 dB (2.83v @ 1 meter) Nominal Impedance 4-6 ohms Power Handling* 50 watts RMS - 200 watts peak Dimensions (Inches H x W x D) 8.25 x 5.25 x 5.25 Weight 2.8 lbs. Finish Black or White * Power handling is based on amplifier volume never being set above the point of audible distortion. All Rights Reserved.
Limited One-Year Warranty This warranty gives you specific legal rights. You may also have other rights which vary from state to state. Dual Electronics Corp. warrants this product to the original purchaser to be free from defects in material and workmanship for a period of one year from the date of the original purchase. Dual Electronics Corp.
