Owner's Manual

Installation
Before You Start
• Consult a qualified technician for instructions. Dual always recommends
professional installation.
• Disconnect negative battery terminal.
• Remove trim ring from unit (if installed).
• Remove 2 transit screws located on top of the unit (if applicable).
• Insert the removal keys, and remove the mounting sleeve from the head unit.
Note: Most vehicles require an installation kit. wiring harness and/ or antenna
adapter (all sold separately) to properly install the head unit in the vehicle.
Installation Process
1. Carefully remove the existing head unit.
2. Connect wiring harness. Consult a qualified technician if you are unsure.
3. Mount the head unit using the mounting sleeve or ISO brackets (depending
on your vehicle's dashboard).
4. Connect wiring harness and antenna. Test the head unit for correct operation.
5. Slide into mounting sleeve to secure. or mount the ISO brackets to the
vehicle.
6. Snap trim ring into place.
Wiring Connections
The chart below the connection for each wire in the wiring harness.
Color
Red
Yellow
Black
Blue
Gray
Gray / Black
Wh i te
Wh i te /Black
Violet
Violet/Black
Green
Green /Black
Connection
12V Ignition / Accessory
12V Battery / Memory
Ground
Power Antenna / Amp Turn-on
Right Front (+)
Right Front (-)
Left Front (+)
Left Front (-)
Right Rear ( +)
Right Rear (-)
Left Rear ( +)
Left Rear(-)
Tip:
When a suitable ground wire is
not present in the vehicle wiring
harness. connect the black ground
wire to the vehicle chassis.
Fuse :
When replacing the fuse. make
sure new fuse is the correct type
and amperage. Using an incorrect
fuse could damage the radio.