Owner's Manual
Table Of Contents
Installation
,-'
E
,,
.. ,, 3 In
~---
Mounting
the
Radio
1.
Choose a mounting location
on
the dash board
or
instrument panel that
will
allow room behind to run radio cables to the power source. Consider how you
will
use the
AUX
IN.
LINE
OUT
and
USB
connectors and route the appropriate
extension cables to
an
accessible area.
2.
Cut
a hole in the dash board using the template provided in the back of this
manual. At least 3 3/4" depth is needed to mount the radio.
IMPORTANT!
Do
not
mount
this unit
where
it
can
be
submerged
in
water.
3.
Slide the included spring washers (8) over the screw posts
(A)
and attach the
screw posts to the back of the radio.
4.
Place the radio in front of the dashboard opening so the wiring can
be
brought
through the opening.
5.
After completing the wiring connections. turn the radio
on
to confirm operation
(vehicle accessory switch must
be
on).
If the radio does not operate. recheck
all
wiring until the problem is corrected.
Once
proper operation is achieved.
turn the accessory switch off and proceed with final mounting of the radio.
NOTE:
Before final installation. test the wiring connections to make sure the unit
is connected properly and the system works.
6.
Insert the radio into the mounting hole.
7. Place the "U" bracket
(C)
over the screw posts and secure the radio to the
dash using the included hex nuts
(D).
If necessary. cut the score marks
(E)
on
either side of the mounting bracket to custom fit the bracket length for your
application.
See
Figure
A.