MRF40 Marine RF Remote Control Installation and Owner·s Manual
MRF40 Installation Installing the MRF40 receiver 1. 2. 3. Connect the 3.5mm cable to the REMOTE IN input on the back of the radio. Connect the black wire from the MRF40 receiver to a good ground (-) source. Typically. the ground wire connection from the radio wiring harness can be used. Connect the red wire from the MRF40 receiver to a 12 volt accessory switched power source. This may be connected to the red accessory power wire at the radio wiring harness.
MRF40 Installation Initial setup 1. Turn on the power to the radio and MRF40 receiver. A blue LED should be visible through the top of the receiver. 2. Link the MRF40 remote to the receiver by pressing and holding the MUTE button on the MRF40 remote for 5 seconds. while the remote is within 3 feet of the receiver. The LED on the receiver will flash to confirm the connection. Note: this step must be repeated if the battery is removed from the MRF40 remote. I Mounting the MRF40 receiver 1. 2. 3.
•• MRF40 Button Functions Ill G) 0 0 Mute G) Volume Down Volume Up ® Track/Tune Up Track/Tune Down G) Mode 4
Ill MRF40 Replacing the Battery Opening the MRF40 Remote Using a small screwdriver or pick tool. carefully remove the 3 rubber plugs on the backside of the MRF40 remote control. exposing the screws. ' Using a small Phillips screwdriver. remove the 3 screws. saving the screws and rubber plugs for reassembly. Carefully remove the back cover and set aside. Changing the Battery Remove the installed battery by sliding the battery out of the its slot to the left.
•• MRF40 Replacing the Battery Replacing the Back Cover Carefully place the back cover on the MRF40 remote. Ensure the edges of the back cover fit inside the groove in the rubber seal. Reinstalling the Screws and Rubber Plugs While holding the back cover in place. insert the 3 screws back in the holes using a small Phillips screwdriver. Do not overtighten the screws. or the waterproof seal may be damaged. Replace the rubber plugs securely.
Ill MRF40 FCC Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference. and (2) this device must accept any interference received. including interference that may cause undesired operation. , Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Warranty This warranty gives you specific legal rights. You may also have other rights which vary from state to state. Dual Electronics Corp. warrants this product to the original purchaser to be free from defects in material and workmanship for a period of one year from the date of the original purchase. What to do? 1. Before you call for service. check the troubleshooting guide in your owner's manual. A slight adjustment of any custom controls may save you a service call. 2.
