XDM7610 INSTALLATION/OWNER’S MANUAL AM/FM/CD/MP3/WMA Receiver with Detach Face
XDM7610 INSTALLATION Preparation Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. Consult a qualified technician for instructions. • Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration. Getting Started • Remove trim ring from unit, • Remove 2 transit screws located on top of the unit.
XDM7610 INSTALLATION Wiring Diagram FUSE When replacing the fuse, make sure new fuse is the correct type and amperage. Using an incorrect fuse could damage the radio. The XDM7610 uses one 10 amp ATM fuse located beside the wiring connector.
XDM7610 OPERATION Control Locations - Receiver 1 25 2 3 24 23 4 22 6 5 21 20 7 8 19 9 18 10 17 1 Tune/Track Down 14 Mute 2 Mode/Search 15 Tuner Scan/*Key #8 3 Tune/Track Up 16 *Key #9 4 Preset #2/Repeat 17 *Key #0 5 Preset #1/Folder Down 18 Band/Play/Pause 6 Open 19 Infrared Sensor 7 Volume 20 Power 8 Eject 21 Preset #5 9 Preset #6/Folder Up 22 Preset #4/Intro 10 *Key #7 23 Preset #3/Random 11 EQ 24 Reset 12 Audio/Setup 25 AS/PS/Enter 13 D
XDM7610 OPERATION Control Locations - Remote 1 2 3 19 4 18 5 17 6 7 16 8 15 9 14 10 13 11 12 1 Power 11 EQ 2 Volume Up 12 Open 3 AS/PS/Enter 13 Display 4 Audio/Setup 14 Preset #5 5 Tune/Track Up 15 Preset #4/Intro 6 Mute 16 Preset #1/Folder Down 7 Volume Down 17 Mode/Search 8 Preset #3/Random 18 Tune/Track Down 9 Preset #2/Repeat 19 Band/Play/Pause 10 Preset #6/Folder Up 5
XDM7610 OPERATION General Operation Front Panel Note: Front Panel Removal Power On/Off Mode Volume Mute The front panel is semi-permanently attached during assembly. Please refer to the separate yellow instructions (before installation) to make the front panel removable. With the unit off, press OPEN to allow the front panel to slide down. Gently squeeze the release tab located on the bottom center underside and pull front panel down and away from unit to remove.
XDM7610 OPERATION General Operation - Setup Menu Setup Menu Press and hold SETUP for more than 3 seconds to access the setup menu. Press SETUP momentarily to select between the menu functions and rotate the rotary encoder left/right to adjust or activate the desired function.
XDM7610 OPERATION General Operation - Audio Settings Audio Press AUDIO momentarily to select between Volume (default), Bass, Treble, Balance, Fader & Subwoofer. VOLUME BASS TREBLE BALANCE FADER SUBWOOFER Bass Press AUDIO until BAS appears then rotate encoder left/right to adjust ( -6 minimum / +6 maximum). Treble Press AUDIO until TRE appears then rotate encoder left/right to adjust ( -6 minimum / +6 maximum).
XDM7610 OPERATION Seek Tuning Manual Tuning Tuner Operation Press TUNE nn or TUNE ll momentarily to seek the next strong station. nn ll Press TUNE or TUNE for more than 2 seconds, then release. "MANUAL" will momentarily appear in the display. Press TUNE or TUNE momentarily to move radio frequency up or down one step at a time. Press and hold to advance quickly. If tuning is not adjusted for 5 seconds, the unit will return to seek tuning mode (default). "AUTO" will momentarily appear in the display.
XDM7610 OPERATION CD Player Operation Insert CD With the label facing up, insert a standard size CD into the CD slot. The CD will automatically begin playback. Eject CD Press EJECT to eject the CD. The unit will change to previous mode of operation (AM, FM, or auxiliary input). If the disc is not removed within 10 seconds, the unit will reload the disc. The unit does not have to be turned on to eject CD.
XDM7610 OPERATION CD Player Operation - MP3/WMA Files Playing an MP3/WMA Disc When an MP3/WMA encoded disc is first inserted, “READING” will appear in the display. Depending on the number of files and folders, this may take several seconds. MP3 Icon The icon will illuminate anytime a valid MP3 encoded disc is inserted and flash in MP3 search/navigate modes. WMA Icon The icon will illuminate anytime a valid WMA encoded disc is inserted and flash in WMA search/navigate modes.
XDM7610 OPERATION CD Player Operation - MP3/WMA Files Refer to the following button function table when selecting, searching or navigating MP3/WMA files and folders: MP3/WMA Button Function Table Button Function SEARCH Direct Select, Search and Navigate Modes Enter/Confirm Preset #1 A, B, C, 1 Preset #2 D, E, F, 2 Preset #3 G, H, I, 3 Preset #4 J, K, L, 4 Preset #5 M, N, O, 5 Preset #6 P, Q, R, 6 Key #7 S, T, U, 7 Key #8 V, W, X, 8 Key #9 Y, Z, /, 9 Key #0 -, _, +, 0 AUDIO Charact
XDM7610 OPERATION CD Player Operation - MP3/WMA Files Alphanumeric File or Folder Search Step 1 Press SEARCH for more than 3 seconds, then release. Press SEARCH again, an " " will flash in the display. Use the buttons in the table on page 12 (32 character maximum input) or the rotary encoder to enter the desired alphanumeric search characters. Press AUDIO to advance one character to the right. * Step 2 Press Step 3 Turn the rotary encoder to preview the search results.
XDM7610 OPERATION CD Player Operation - MP3/WMA Files Navigating Note *Folder Access After navigating by direct select, alphanumeric search or file/folder navigate modes, the track number and elapsed time will be displayed by default. Press DISP momentarily to select clock, track name, directory name, title, artist, album, year or comment. Press Press to select the previous folder. to select the next folder. *Folder access is only available on MP3/WMA discs recorded with more than one folder.
XDM7610 OPERATION CD Player Operation - MP3/WMA Files Media Compatibility The following types of discs/files are compatible: • CD-ROM (ISO), CD-R, CD-RW • CD-DA • MP3 data • WMA data The following types of discs/files are not compatible: • WMA files that are protected by DRM (Digital Rights Management).
XDM7610 OPERATION CD Player Operation - MP3/WMA Files Additional MP3/WMA Information An internal buffer provides ESP (Electronic Skip Protection) to virtually eliminate skipping. When playing a disc recorded with regular audio files (CD-DA or .WAV) and MP3/WMA files, the unit will play the MP3/WMA files only. Only MP3 files with filename extension (.mp3) can be played. Only WMA files with filename extension (.wma) can be played.
XDM7610 WARRANTY Limited One Year Warranty This warranty gives you specific legal rights. You may also have other rights which vary from state to state. Dual Electronics Corp. warrants this product to the original purchaser to be free from defects in material and workmanship for a period of one year from the date of the original purchase. Dual Electronics Corp.
XDM7610 OPERATION Specifications CD Player Frequency response: 10Hz-20kHz Channel separation @ 1kHz: >65dB D/A converter: 1 Bit FM Tuner Tuning range: 87.5MHz-107.9MHz Usable sensitivity: 8.5dBf 50dB quieting sensitivity: 10dBf Stereo separation @ 1kHz: 40dB Frequency response: 30Hz-13kHz AM Tuner Tuning range: 530kHz-1710kHz Usable sensitivity: 22uV Frequency response: 30Hz-2.
XDM7610 OPERATION Troubleshooting Problem Unit will not turn on (no power) Cause Black wire not connected Unit has power (but no sound) Unit blows fuses Action Yellow wire not connected or incorrect voltage Check connections for proper voltage (11~16VDC) Red wire not connected or incorrect voltage Check connection to ground Fuse blown Replace fuse Speaker wires not connected Check connections at speakers One or more speaker wires touching each other or touching chassis ground Insulate all bare sp
Dual Electronics Corp. Toll Free: 1-866-382-5476 www.dualav.com ©2006 Dual Electronics Corp. All rights reserved. Windows Media and the Windows logo are trademarks, or registered trademarks of Microsoft Corporation in the United States and or other countries.