XR4120 INSTALLATION/OWNER'S MANUAL AM/FM Receiver with Detachable Face
XR4120 INSTALLATION Preparation Please read entire manual before installation.
XR4120 INSTALLATION Wiring Diagram Antenna Connector 10 AMP AGC Fuse FUSE 7HEN REPLACING THE FUSE MAKE SURE NEW FUSE IS THE CORRECT TYPE AND AMPERAGE 5SING AN INCORRECT FUSE COULD DAMAGE THE RADIO 4HE 82 USES ONE AMP !'# FUSE LOCATED in-line.
XR4120 OPERATION Control Locations - Receiver 2 3 5 9 8 2ELEASE 0RESET )NTRO 2 0OWER 0RESET 2ANDOM 3 Volume Knob 0RESET 2EPEAT !UDIO -ENU $ISPLAY 5 53" 0ORT 4UNE 5P 6 !UXILIARY )NPUT 4UNE $OWN 7 0RESET &OLDER 5P "AND 'O "ACK 8 0RESET &OLDER $OWN Mode 9 0RESET 0LAY 0AUSE Mute 7 6
XR4120 OPERATION Control Locations - Remote 1 2 3 17 4 16 6 5 15 5 6 14 4 7 13 8 12 9 11 10 0OWER 0RESET &OLDER 5P 2 6OLUME 5P 0RESET &OLDER $OWN 3 3ELECT 0RESET 0LAY 0AUSE 4UNE 5P 0RESET 2EPEAT 5 6OLUME $OWN 0RESET 2ANDOM 6 !UDIO -ENU Mode 7 $ISPLAY "AND 'O "ACK 8 Mute 4UNE $OWN 9 0RESET )NTRO 5
XR4120 OPERATION General Operation Faceplate Removal Power On/Off Mode Display Press RELEASE AND PULL AWAY FROM THE LEFT SIDE TO REMOVE 4O RE INSTALL INSERT RIGHT SIDE OF FACEPLATE FIRST THEN PUSH LEFT SIDE TO SECURE Press or any other button TO TURN THE UNIT ON 0RESS AGAIN TO TURN THE UNIT OFF Press MODE TO SELECT BETWEEN !- &- 53" 3$ OR AUXILIARY INPUT MODES -ODES OF OPERATION ARE INDICATED IN THE DISPLAY 3$ AND 53" MODES WILL NOT APPEAR UNLESS AN 3$ #ARD IS INSERTED OR A 53" DEVICE IS CONNECTE
XR4120 OPERATION General Operation Audio / Menu 0RESS THE volume knob TO SELECT BETWEEN "ASS 4REBLE "ALANCE &ADER ,OUDNESS $ISTANCE AND 3TEREO BASS TREBLE BALANCE FADER LOUDNESS Bass 0RESS THE volume knob until BAS APPEARS 2OTATE THE volume knob LEFT RIGHT TO ADJUST MINIMUM MAXIMUM Treble 0RESS THE volume knob until TRE APPEARS 2OTATE THE volume knob LEFT RIGHT TO ADJUST MINIMUM MAXIMUM DISTANCE STEREO Balance 0RESS THE volume knob until BAL APPEARS 2OTATE THE volume knob
XR4120 OPERATION AM/FM Tuner Operation Press TUNE nn or TUNE ll MOMENTARILY TO SEEK TO THE Seek Tuning NEXT STRONG STATION 0RESS AND HOLD TUNE nn or TUNE ll UNTIL -!.
XR4120 OPERATION USB / SD Card Operation Repeat Random Intro Character Support Media Compatibility 0RESS 204 TO CHOOSE BETWEEN s #URRENT 3ONG #ONTINUOUSLY REPEATS SELECTED TRACK s #URRENT &OLDER #ONTINUOUSLY REPEATS ALL FILES IN FOLDER 0RESS 2$- TO CHOOSE BETWEEN s /FF #ANCELS 2$- FUNCTION s !LL 3ONGS 0LAYS ALL TRACKS IN RANDOM ORDER s #URRENT &OLDER 0LAYS ALL TRACKS IN FOLDER IN RANDOM order. 0RESS ).
XR4120 OPERATION USB / SD Card Operation Playback Capacity s -AXIMUM NUMBER OF FILES s -AXIMUM NUMBER OF FOLDERS s -AXIMUM NUMBER OF FOLDER LEVELS SUB FOLDERS Note: )F THE NUMBER OF FILES FOLDERS EXCEEDS THE MAXIMUM OUTLINED ABOVE THE ADDITIONAL FILES FOLDERS WILL BE IGNORED Note: $EVICES THAT EXCEED THE MAXIMUM NUMBER OF FILES OR FOLDERS MAY NOT FUNCTION PROPERLY USB Device Compatibility $UE TO THE DIFFERENCES OF 53" DEVICES SOME DEVICES MAY NOT BE COMPATIBLE 53" DEVICES MUST BE @MAS
XR4120 OPERATION Troubleshooting Problem Unit will not turn on (no power) Unit has power (but no sound) #AUSE !CTION 9ELLOW WIRE NOT CONNECTED OR INCORRECT VOLTAGE 2ED WIRE NOT CONNECTED OR INCORRECT VOLTAGE "LACK WIRE NOT CONNECTED &USE BLOWN 3PEAKER WIRES NOT CONNECTED #HECK CONNECTIONS FOR PROPER VOLTAGE ^ 6$# /NE OR MORE SPEAKER WIRES TOUCHING EACH OTHER OR TOUCHING CHASSIS GROUND #HECK CONNECTION TO GROUND 2EPLACE FUSE #HECK CONNECTIONS AT SPEAKERS )NSULATE ALL BARE SPEAKER WIRES FROM EACH
XR4120 OPERATION Limited One Year Warranty 4HIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS 9OU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE $UAL %LECTRONICS #ORP WARRANTS THIS PRODUCT TO THE ORIGINAL PURCHASER TO BE FREE FROM DEFECTS IN MATERIAL AND WORKMANSHIP FOR A PERIOD OF ONE YEAR FROM THE DATE OF THE ORIGINAL PURCHASE $UAL %LECTRONICS #ORP AGREES AT OUR OPTION DURING THE WARRANTY PERIOD TO REPAIR ANY DEFECT IN MATERIAL OR WORKMANSHIP OR TO FURNISH AN EQUAL NEW RENEWED OR COMPARABLE PR
XR4120 OPERATION FCC Compliance 4HIS DEVICE COMPLIES WITH 0ART OF THE # 2ULES /PERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE AND THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION Warning #HANGES OR MODIFICATIONS TO THIS UNIT NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE COULD VOID THE USER S AUTHORITY TO OPERATE THE EQUIPMENT Note: 4HIS EQUIPMENT HAS BEEN TESTED AN
XR4120 OPERATION Specifications FM Tuner 4UNING RANGE 87.5MHz-107.9MHz 5SABLE SENSITIVITY 10dBf D" QUIETING SENSITIVITY 25dbu 3TEREO SEPARATION K(Z >30dB &REQUENCY RESPONSE 30Hz-13kHz AM Tuner 4UNING RANGE 530kHz-1710kHz 5SABLE SENSITIVITY <42dBu &REQUENCY RESPONSE 30Hz-2.
XR4120 OPERATION Notes
$UAL %LECTRONICS #ORP 4OLL &REE !- 0- %34 -ONDAY &RIDAY WWW DUALAV COM ¥ $UAL %LECTRONICS #ORP !LL RIGHTS RESERVED /THER TRADEMARKS AND TRADE NAMES ARE THOSE OF THEIR RESPECTIVE OWNERS .
Quick Start Guide For Mechless and CD Receivers Not all features listed in this QSG are available on all models. • • • • • • • • • • • • • • • • To download the complete. model-specific manual. please visit www.dualav.com/support/manuals.php or call 1-866-382-5476. 9AM-5PM EST (Monday-Friday).
Installation Before You Start • Consult a qualified technician for instructions. Dual always recommends professional installation. • Disconnect negative battery terminal. • Remove trim ring from unit (if installed). • Remove 2 transit screws located on top of the unit (if applicable). • Insert the removal keys. and remove the mounting sleeve from the head unit. Note: Most vehicles require an installation kit.
Installation Dashboard or Installation Kit Mounting the Head Unit: Typical DIN mounting Step 1: Insert the mounting sleeve into the installation kit or dashboard. Dashboard or Installation Kit I Step 2: Bend multiple mounting tabs around the mounting sleeve until the mounting sleeve is secure. Dashboard or Installation Kit Step 3: Connect all wiring harnesses and slide the head unit into the mounting sleeve until it clicks into place.
General Operation Press the cb button to turn the unit on. Press cb again to turn unit off. Power On/Off Faceplate Removal Changing Modes Press RELEASE and pull away from the left side to remove. To re-install. insert right side of faceplate first then push left side to secure. Press MODE to select between AM/FM. CD player. 1 auxiliary front/rear. USB and operation of iPod/iPhone. I Modes of operation are shown in the I display. f Volume Adjust volume using volume knob.
AM/FM Tuner Operation Seek Tuning I I Press TUNE ~~ or TUNE ~~ for more than one ~, Press TUNE ~~ or TUNE ~~ momentarily to move second to seek to the next strong station. Manual Tuning radio frequency up or down one step at a time. Press and hold to advance quickly. Band I_ Press BAND to select between FM1. FM2. FM3. AM1 - and AM2 bands. Up to six presets can be programmed for each band. enabling up to 18 FM stations and 12 AM stations to be stored in memory.
Insert CD Ejed CD Track Seled I With the label facing up. insert a standard size CD into the CD slot. Playback will begin automatically. II Press EJECT (located behind the front panel) to eject the CD. The unit will change to previous mode of operation. II Press TUNE ...,.....,.. to skip to the beginning of the next I track. Press TUNE ..,.....,... to return to the beginning of the current track. Pressing TUNE .......... again skips to the beginning of the previous track. I Press and hold TUNE ...,.
MP3/ WMA Operation * To play MP3/WMA files. insert a data CD. SD card or USB device containing MP3/WMA files. Playing MP3/WMA Files Track Select . Press TUNE ....,.....,. to skip to the beginning of the next song. Press TUNE ..,.....,... to return to the beginning of the current song. Pressing TUNE ..,.....,... again skips to the beginning of the previous song. Press and hold TUNE ....,....,. or TUNE ..,.....,... to fast forward or reverse a track. Fast Forward and Reverse Press Press Pause ...,.
Operation of iPod/iPhone* Connect an iPod/ I To play music from an iPod/iPhone device. connect the USB iPhone Device (sold I cable (included with your iPod/iPhone device) to the unit's USB 1 port. Playback will begin automatically. separately) i j Song Select Forward/Reverse Pause 1 Press ...,....,. i 1 to skip to the next song. Press ..,.....,... to return to the beginning of the current song. Pressing ..,.....,... again skips to the beginning of the previous song. 1I Press and hold...,....,. or.
Bluetooth® Operation* Preparation Before using a Bluetooth device. it must be paired and connected. Ensure that Bluetooth is activated on your device before beginning the pairing process. Pairing a New Device The head unit broadcasts the pairing signal constantly when no devices are connected. Complete the pairing sequence from your Bluetooth device. Refer to the owner's manual for your device for more details.
Pandora® Operation* Requirements ~ Control for Pandora requires: • An iPhone device with a reliable data connection. or an iPod touch that is connected to wireless internet. • The Pandora App installed on the iPhone/iPod device. • An active account with Pandora (www.pandora.com). • The USB sync cable included with iPod/iPhone device. I USB Connection I I I ~ ;I ·~ Connect an iPod touch or iPhone device (required. sold separtely) to the USB port.
Limited One-Year Warranty This warranty gives you specific legal rights. You may also have other rights which vary from state to state. Dual Electronics Corp. warrants this product to the original purchaser to be free from defects in material and workmanship for a period of one year from the date of the original purchase. (Note that select marine products carry a 2-year warranty. Please visit www.dualav.com for details.) Dual Electronics Corp. agrees. at our option. during the warranty period.
FCC Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference. and (2) this device must accept any interference received. including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.