User's Manual

DE-ABCM User Manual
Version. 1.02 DUALi Inc.
(http://www.duali.com)
10
REGULATORY INFORMATION
● Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may
cause undesired operation of the device.
. ● Caution
Any changes or modifications NOT explicitly APPROVED by DUALi could cause the DE-ABCM module to cease to comply
with FCC rules part 15 and thus void the user's authority to operate the equipment.
● Information to User
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
● Antenna
This device shall only be used with the tested antenna that is integral PCB antenna.
● Label and manual requirements for the End Product
For an end product using the DE-ABCM there must be a label containing, at least, the following information. FCC ID
certification number for model DE-ABCM.
This device contains FCC ID : SWUDE-ABCM—S
The label must be affixed on an exterior surface of the end product such that it will be visible upon inspection in compliance
with the modular approval guidelines developed by the FCC
Where the DE-ABCM will be installed in final products larger than 8cm × 10cm following statements has to be placed ONTO
the device
. "Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause undesired operation."