Operating instructions

C-6
Service Instructions Automatic Multi-Head Serging Machine 1365-4Beisler GmbH
C.3
Start-up
C.3.1 Aligning the machine table
After the machine has been installed at the desired location, the machi-
ne table must be aligned:
 Set machine table to required height.
 Level machine table horizontally on all sides.
Setting the table height:
1. Fig. 1: Lift machine: Connect lifting device at lift points (arrows) be-
low the crossmembers. If the machine is equipped with the optional
transport rollers, release brakes before lifting
2. Loosen locating screws
2
on all table legs.
3. Pull table legs
4
out to the desired length and retighten locating
screws.
4. Tighten the height adjustment locating screws
2
.
5. Lower machine onto floor.
6. Level worktable horizontally in all directions.
7. Tighten the height adjustment locating screws
2
.
NOTE - Shipping braces!
Before the machine is connected to the power supply sy-
stem and operated, all shipping braces must be removed.
 Cut off cable ties.
 Remove labels.
 Remove protective film from operating panel.
C.3.2 Compressed-air connections
Fig. 2: The compressed-air connection is preinstal-
led on the machine. It comprises the following com-
ponents:
 Pressure reducer
2
with manometer
4
and
water separator
4
,
 Pressure hose with push-in plug
3
.
The pressure reducer ist installed to the machine
frame below the B machine.
Connecting the machine to the compressed-air
supply system:
1. Connect pressure hose plug to on-site terminal
unit.
2. Open on-site compressed-air supply.
3. Set pressure reducer to a machine operating
pressure of 6 bar by rotating pressure reducer
knob
1
and read value on manometer
4
:
 To increase pressure, rotate in the clockwise direction.
 To reduce pressure, rotate in the counterclockwise direction.




Fig. 1
Fig. 2