Operating instructions

9.3 Changing parameter values

9.3.1 Numerical values

Numerical values can be changed in the following way:

–

Use the ñ and ò cursor keys to select the line containing the value

you wish to change.

–

Press the enter key.

The cursor flashes under one digit of the numerical value.

–

Use the ï and ð cursor keys to move from one digit to another.

Use the ñ and ò cursor keys to increase or reduce the value of the

selected digit.

Where parameters are limited to certain values (e.g. eye shape),

pressing the ñ and ò cursor keys displays another possible

parameter value.

–

Press OK.

The set value is accepted.

–

If the set value is not to be accepted, press “ESC”.

The original value is restored.

9.3.2 Selecting a parameter

Some parameters allow selection among a number of possibilities.

These parameters can be changed in the following way:

–

Use the ñ and ò cursor keys to select the line containing the

parameter or value to be changed.

–

Press OK.

–

Use the ñ and ò cursor keys to switch from one possibility to another.

The selected symbol appears in the display.

Exception:

to switch cut mode use the ï and ð cursor keys.

–

Press the enter key.

The set parameter or value is accepted.

–

If the set parameter or value is not to be accepted, press “ESC”.

The original parameter or value is restored.