Operating instructions

ManualsBrandsDuerkopp Adler ManualsBusiness equipment841-27

ATTENTION !

During the use of the setting program do not turn on the handwheel or

the hand crank!

–

If necessary, lower the sewing arch by pressing the

F3 key

–

With the setting aid still turned on, the knife block can now be

moved downward with the

F4 key

–

By pressing the

key

again the knife block can be run up again.

If the sewing arch is not lowered the knife block can not be run

downward with the

key

. First the sewing arch must then be lowered

with the

key

. Also the function of the

F3 key

(lift sewing arch) is

blocked with the knife lowered.

Aligning the knife

The front edge of the knife should lay

approx. 2 mm

under the upper

edge of the needle plate with the knife block lowered.

Setting:

–

Lift the sewing arch.

–

Slightly loosen nut 1.

–

Move the knife.

–

Tighten nut 1.

–

Check the incision depth, if necessary repeat the procedure.

The incision of the knife should lie about 2 fabric threads in front of the

last sewn back tack.

Setting:

–

Loosen screw 3 and set the clearance accordingly.

Observe:

With the knife block lowered there

must

be a safety clearance of

0.5 mm

between the front edge of the knife and the slot in the needle

plate insert.

–

Tighten screw 3.

Ending the setting aid

–

Press the "

" key.

The setting program is ended.