Operating instructions
5.1.6 "No Material under Light Barrier" Display
The light barrier 1 checks if material is present. If no material lies
under the light barrier, the indicator at the left appears in the display.
The indicator can appear under following conditions:
–
The material was displaced.
–
The material has run out.
–
The light barrier is incorrectly set.
–
There is no material under the light barrier.
–
The sewing procedure was started unintentionally.
Removing the material
–
Strike the enter key.
The advancing device runs into the base position.
–
Strike the enter key again.
The clamping rail opens.
–
Remove the material.
Realigning the material
–
When the material is realigned so that the light beam is
interrupted, the display changes so that the symbol at the left
appears.
–
Strike the enter key.
The sewing procedure is continued.
Light barrier
If there is still material lying under the light barrier, the sensitivity of
the light barrier must be altered.
–
Turn adjusting screw 3 clockwise until the LED 2 goes out.
"ESC" key function
Dependent on the display, a different function is triggered with the
"ESC" key than with the enter key.
–
The advancing device runs into the base position.
Strike the enter key.
The material can be removed.
–
The next buttonhole is sewn.
1
2
3
24