Operating instructions

3. Switching On/Off

3.1 Switching On

For the operational readiness of the sewing unit the feed rail must be

run into the reference position once after switching on.

The reference position is required in order for the controls to receive a

defined base position for the feed rail.

Caution Risk of Injury !

Do not reach into the motion area of the feed rail 3 during the

reference run.

–

Turn on the switch 1 of the head of the sewing machine.

–

Turn on the main switch 2.

The controls load the machine program.

The DÜRKOPP-ADLER logo appears briefly in the display of the

control panel.

–

The operator is prompted to start the reference run by the

<==== REF

" message.

–

Operate the start switch 5.

The feed rail runs into its left end position.

–

The screen changes to the main display.

The sewing unit is ready for operation.

–

For switching the rotary blower (optional equipment) on: turn the

switch of the rotary blower to the "I" position.

3.2 Switching Off

–

Turn off the main switch 2.

–

Turn off the switch 1 of the head of the sewing machine.

–

The sewing unit is disconnected from the power supply.

It is no longer ready for operation.

–

For switching the rotary blower (optional equipment) off: turn the

switch to the 0 position.