Installation and Operating Instructions

ManualsBrandsDUERR DENTAL SE ManualsElectronicsThe image plate scanner is used to read image data stored on an image plate and to transfer the data to the imaging software on a computer.

20 2160100227L02 2001V008

Assembly

i Remove the screw covers and screws from

the bottom of the device.

i Remove the cover from the rear of the device.

7.2 Electrical connections

Safety when making electrical connections

i The device must only be connected to a cor-

rectly installed power outlet.

i Do not place non-ﬁxed multi-socket units on

the ﬂoor. Follow the requirements in sec-

tion16 of IEC60601-1 (EN60601-1).

i

Do not operate any other systems using the

same multiple socket.

i Make sure that none of the electrical cables

leading to the unit are under any mechanical

tension.

i Before initial start-up check that the mains

supply voltage and the voltage stated on the

type plate match (see also "4. Technical

data").

Connecting the unit to the mains supply

The unit has no main power switch. For

this reason it is important that the unit is

be set up in such a way that the plug can

be easily accessed and unplugged if re-

quired.

Requirements:

– Properly installed power outlet close to the

unit (observe the max. mains cable length)

– Easily accessible power outlet

– Mains voltage must match the information

shown on the type plate of the power supply

unit

Only the supplied power supply unit may

be used.

i Attach the matching country-speciﬁc adapter

to the power supply unit.

EN

2160100227L29_1910V008_US-EN_nur FCC-Zulassung_V2.indd 20 14.01.2020 11:04:08