Installation and Operating Instructions

ManualsBrandsDUERR DENTAL SE ManualsElectronicsThe image plate scanner is used to read image data stored on an image plate and to transfer the data to the imaging software on a computer.

40 2160100227L02 2001V008

Troubleshooting

Fault Probable cause Solution

X-ray image has strips on

image

Image plate has been pre-ex-

posed, e.g. by natural radiation or

stray X-ray radiation

i If the image plate has been

stored for longer than one week,

erase the image plate prior to

use.

Parts of image plate exposed to

light during handling

i Do not expose used image

plates to bright light.

i Scan image data within half an

hour after the exposure.

Image plate dirty or scratched i Clean the image plate.

i Replace scratched image plates.

Unit was shaken by impact or in-

put unit cover was closed during

scanning process

i Set up the unit so that it cannot

be shaken.

i Prevent the unit from being

touched during the scanning

process.

Light strips in the scan-

ning window

Too much incident ambient light

during the scanning process

i Darken the room.

i Turn the unit so that the light

does not fall directly onto the

input unit.

X-ray image with small

bright spots or clouding

Micro scratches on the image

plate

i Replace the image plate.

Lamination of the image

plate becoming detached

at the edge

Incorrect retainer system used i Only use original image plates

and ﬁlm retainer systems.

Image plate handled incorrectly. i Use the image plate correctly.

i Observe the operating instruc-

tions for the image plates and

ﬁlm retainer systems.

The X-ray image shows a

pre-erasure at one end

After the barrier envelope has

been torn off and before pushing

the PSP into the input unit, the

phosphor storage plate is pushed

out of the light protection cover

i Do not push out the image plate

until the torn-off light protection

cover has been placed on the

input unit.

2160100227L29_1910V008_US-EN_nur FCC-Zulassung_V2.indd 40 14.01.2020 11:04:18