Instruction Manual

ManualsBrandsDuff-Norton ManualsHardwareEM1010-100 (TMD02)

The equipment shown in this manual is intended for industrial use only and should not be used to lift, support, or otherwise

transport people unless authorized in writing by Duff-Norton.

CAUTION!

This manual contains important information for the correct installation, operation and maintenance of the equipment

described herein. All persons involved in such installation, operation, and maintenance should be thoroughly familiar with

the contents. To safeguard against the possibility of personal injury or property damage, follow the recommendations and

instructions of this manual and keep it for further reference.

WARNING!

EM-1010-100_0706 7/31/07 2:40 PM Page 6

Summary of content (6 pages)

PAGE 1
EM-1010-100_0706 7/31/07 2:40 PM Page 6 CAUTION! This manual contains important information for the correct installation, operation and maintenance of the equipment described herein. All persons involved in such installation, operation, and maintenance should be thoroughly familiar with the contents. To safeguard against the possibility of personal injury or property damage, follow the recommendations and instructions of this manual and keep it for further reference.
PAGE 2
EM-1010-100_0706 7/31/07 2:40 PM Page 1 CONTENTS INTRODUCTION 1-1 1-2 1-3 1-4 1-5 1-6 General Information Application Information Specifications Dimensions Performance Wiring Diagram (limit switch models) 3 3 3 3 4 4 INSTALLATION 2-1 2-2 2-3 2-4 Direction of Loading Limit Switches Wiring Connections Limit Switch Adjustment 5 5 5 5 OPERATION 3-1 Operating Conditions 5 INSPECTION AND MAINTENANCE 4-1 4-2 4-3 4-4 Safety Note Inspection Maintenance Lubrication WARRANTY 5 5 5 5 6 INTRODUCTION 1-1
PAGE 3
EM-1010-100_0706 7/31/07 2:40 PM Page 2 1-3 Specifications Stroke Lengths: Duty Cycle: Input Power: Ambient Temperature: Motor Protection: 2, 4, 6, 8, 10, & 12 inch. Special lengths on application. 25% max. on time at rated load and 25˚C ambient. 12 or 24 VDC, depending on model. -20˚F to 120˚F (-29˚C to 50˚C) External fusing by installer recommended; 8 amp rating, standard time response. Limit switch models include internal fusing. By motor fusing (see above).
PAGE 4
EM-1010-100_0706 7/31/07 2:40 PM Page 3 TracMaster 100 Performance Charts Speed (mm/min) in/min Speed vs. Load Load vs. Duty Cycle (12 & 24 VDC) Amp Draw vs.
PAGE 5
EM-1010-100_0706 7/31/07 2:40 PM Page 4 INSTALLATION 2-1 Direction of Loading Duff-Norton electromechanical actuators can be used in tension, compression, or combination tension/compression applications. Examples are as shown below. PROPER LOADING Tension Compression It is important to mount the actuator so that side loading or eccentric loading are avoided.
PAGE 6
EM-1010-100_0706 7/31/07 2:40 PM Page 5 DUFF-NORTON ELECTROMECHANICAL ACTUATOR LIMITATION OF WARRANTIES, REMEDIES AND DAMAGES The warranty stated below is given in place of all other warranties, express or implied, of merchantability, fitness for a particular purpose or otherwise. No promise or affirmation of fact made by any agent or representative of seller shall constitute a warranty by seller or give rise to any liability or obligation.