User`s manual

Model 220/340 Press User's Manual
Page 34 Dukane Part No. 403–556–03
Installing the Distance Encoder
Purpose
To install and calibrate the distance encoder in order to accurately measure
the distance of thruster travel.
Requirements
Parts
Kit consisting of the following:
1. 625-14 Encoder (2 pieces)
2. Encoder Head cable cover bracket
3. Mounting screws and hardware
Tools
• Phillips-head screwdriver
• Feeler gauge set (0-.050 inches) or metric equivalent
• 6 inch ruler or metric equivalent
Installation Instructions
Dismantling
1. Facing the front of the press, remove the panel from the right side
of the press. (See Figure 4-5.)
Reassembly
1. Mount the cable cover bracket from the kit and secure it with athead
screws.
2. Attach the encoder scale to the mounting screw holes in the right side
of the thruster with pan-head screws. Do not tighten.
3. Remove the back panel from the press and route the encoder head
cable, being careful not to interfere with the press movement.
Right Side
Panel
Encoder
Head
Encoder Scale
Figure 4-5 Distance Encoder Mounting