User manual

English - 41
Chapter 11 Troubleshooting
This chapter describes problems you may encounter while using DVP508. If you
have questions, please refer to related chapters and follow all the suggested
solutions. If the problem still occurred, please contact our distributors or service
center.
No.
Issues
Solutions
1
Boot without power
Make sure you have plugged in the power cord.
2
No image output
from the
1. Check the power.
2. Check the connection, Refer to User Manual
Chapter 4 Installation and Connections
3. Check the , refer to User Manual Chapter 8
Descriptions of major functions 8.3 I would like to
switch image sources.
4. Check the settings for the source of the projector. For
the appropriate input selection of the projector, refer to
the projectors user manual.
5. Check if DIP Switch is properly set. Refer to User
Manual Chapter 6 DIP Switch Settings for related
settings.
3
Unable to focus
Probably the document is too close. Press [Zoom -] on the
remote control or control panel. Or pull away the
distance between document and lens, then press [AF].
4
The image is
incomplete
Check the Auto Image setting of your projector. Please refer
to the user manual of the projector.
5
Forget the
password for
turning on
Please contact your distributor or the service center.
6 Dukanes Document 󰜁 Dukane
Camera, Dukanes
and other
applications cannot
be used
simultaneously
Document Camera, Dukanes and other
applications cannot be executed simultaneously. Please
close the currently running applications and then execute
the application to be used.
7
When the unit is
turned on, the
auxiliary floodlight
Please make sure the arm lamp is set to [OFF]. For the
switch-on or -off of arm lamp, refer to User Manual
Chapter 8 Descriptions of major functions 8.8 I would
DVP508