Installation Guide
www.factorybuysdirect.com
200257-01A24
CAUTION: Never use a wire,
needle, or similar object to clean
ODS/pilot. This can damage
ODS/ pilot unit.
Use a vacuum cleaner, pressurized air, or a
small, soft bristled brush to clean.
A yellow tip on the pilot ame indicates dust
and dirt in the pilot assembly. There is a small
pilot air inlet hole about 2" from where the
pilot ame comes out of the pilot assembly
(see Figure 31). With the unit off, lightly blow
air through the air inlet hole. You may blow
through a drinking straw if compressed air is
not available.
Figure 31 - Pilot Inlet Air Hole
CARE AND MAINTENANCE
ODS/PILOT
CABINET
Air Passageways
Use a vacuum cleaner or pressurized air to
clean.
Exterior
• Use a soft cloth dampened with a mild soap
and water mixture.
• Wipe the cabinet to remove dust.
LOGS
• If you remove logs for cleaning, refer to
Installing Logs, page 16, to properly replace
logs.
• Replace log(s) if broken or chipped (dime-
size or larger).
ELECTRICAL
ELECTRICAL CONNECTION
FOR STOVES EQUIPPED WITH A BLOWER
Do not use this stove if any
part of it has been under water.
Immediately call a qualied ser-
vice technician to inspect the
stove and replace any part of
the electrical system which has
been under water.
GROUNDING INSTRUCTIONS
This stove is for use on 120 volts. The cord
has a plug as shown at A in Figure 32. An
adapter as shown at C is available for con-
necting three-blade grounding-type plugs to
two-slot receptacles. The green grounding
lug extending from the adapter must be
connected to a permanent ground such as
Grounding Pin
Grounding Means
Metal Screw
Cover of
Grounded
Outlet Box
A
B
C
Adapter
Figure 32 - Grounded Electrical Outlet
a properly grounded outlet box. The adapter
should not be used if a three-slot grounded
receptacle is available.
(Sold
Separately)
(Back of pilot
shown for clarity)
Pilot Air
Inlet Hole
Natural Gas
Burner
Propane/LP
Gas Burner
Thermocouple
Pilot Air Inlet Hole
Ignitor
Electrode