Instructions / Assembly

www.usaprocom.com
7200087-01A
31
1
/
2
"
41
1
/
2
"
1
9
/
16
"
ASSEMBLY INSTRUCTIONS
Figure 13
Figure 14
Figure 15
Figure 12
CC
CC
2) Wall Anchor
Hardware Used
12. After assembling the mantel, carefully lift to the upright position.
Push the replace insert from the front of the mantel as shown in
Figure 12.
13. Drill two holes (5/16") in the corner where the replace is to be
displayed. Drill the rst hole 37
7
/
8
" from the ground up. Drill the
second hole 1
9
/
16
" from the rst hole as shown in Figure 13. Place
the Wall Anchors (CC) into holes by pinching the anchor tabs
together as shown in Figure 13.
14. Install the Set Square Support (H) to the holes drilled in step 13,
with ST5 Screw 2
3
/
8
" (EE) as shown in Figure 15. This block is
used to support the Top Triangle Panel (F). For thin walls, insert
white key (HH) into wall anchor and push to “pop” open anchor
wings.
15. Push replace into the corner so that the Top Triangle Panel (F) is
resting on top of the Set Square Support (H) as shown in Figure 15.
Hardware Used
EE
HH
2) ST5 Screw 2
3
/
8
"
1) White Key
Mitered Corner
Joints
Mitered Corner
Joints
Baseboard
HH
H
EE
Fireplace Insert
H
F
37
7
/
8
"
30
3
/
4
"