Instructions / Assembly

www.bluegrassliving.com
200470-01A24
TROUBLESHOOTING
Problem Possible Cause Corrective Action
When ignitor button is
pressed in, there is no
spark at ODS/pilot
1. Low battery.
2. Ignitor electrode is not con-
nected to ignitor cable.
3. Ignitor cable is pinched or
wet.
4. Ignitor electrode is posi-
tioned wrong. Ignitor elec-
trode is broken.
5 Broken ignitor cable.
6. Bad piezo ignitor.
1. Replace battery.
2. Reattach ignitor cable
3. Free ignitor cable if pinched
by any metal or tubing. Keep
ignitor cable dry.
4. Replace electrode.
5. Replace ignitor cable.
6. Replace piezo ignitor.
When ignitor button is
pressed in there is a
spark at ODS/pilot but
no ignition.
1. Gas supply is turned o or
equipment shuto valve is
closed.
2. Control knob not in PILOT
position.
3. Control knob not fully
pressed in while pressing
ignitor button.
4. Air in gas lines when in-
stalled.
5. ODS/pilot is clogged.
6. Incorrect inlet gas pressure or in-
let regulator setting is damaged.
7. Depleted gas supply (pro-
pane).
1. Turn on gas supply or open
equipment shuto valve.
2. Turn control knob to PILOT
position.
3. Fully press in control knob
while pressing ignitor button.
4. Continue holding down con-
trol knob. Repeat igniting op-
eration until air is removed.
5. Clean ODS/pilot (see Care
and Maintenance, page 22) or
replace ODS/pilot assembly.
6. Check inlet gas pressure or
replace inlet gas regulator.
7. Contact local propane gas
company.
NG
Figure 28 - Gas Regulator Pressure
Switch
Pressure
Switch Set
Screw
The entire gas delivery piping including con-
nections inside the heater should be leak
tested by the qualied installer. After leak
testing the qualied installer should light the
appliance. Refer to the correct ame pattern
as illustrated on page 21. All ame patterns
should be safely inside the product. If for any
reason they are not, stop use of the appliance
and call for repairs.