Use and Care Manual

19
www.factorybuysdirect.com
200273-01C
INSTALLATION
INSTALLING REMOTE RECEIVER
The remote receiver operates on four AA size
batteries (included). Use ALKALINE batteries
for longer battery life and maximum micropro-
cessor performance.
IMPORTANT: New or fully charged batter-
ies are essential for proper operation of
the remote receiver as the solenoid power
consumption is higher than standard remote
control systems.
Red and Black Wires
from Receiver
Red and Black Wires
from Solenoid Valve
Receiver
Figure 20 - Attaching Remote Receiver to Solenoid Valve
1. Remove battery cover on receiver as
shown on the box. Install four AA size
batteries into receiver, (see Figure 20).
2. Locate red and black wires from solenoid
valve on right side of heater. Connect
wires to receiver, red to red, black to black,
(see Figure 20).
3. Place receiver to the side of the log set,
(see Figure 20).
Ember Material
Burner
Figure 21 - Placing Ember Material
(heater may vary from image shown)
PLACING EMBER MATERIAL
Separate the ember material into light pieces
smaller than the size of a dime. Place the
pieces around the round gas ports starting in
the front of the burner and working your way
toward the back of the burner. Do not place
ember material on the burner ports or the
carry over ports leading to the left and right
rear burner slots.
WARNING: Use only ember
material provided with log set.
Do not add additional ember
material.
Place ember material on front
burner port only. DO NOT PLACE
EMBER MATERIAL ON PORTING
BEYOND THE GRATE, OVER THE
MIDDLE OR BACK BURNERS.