Instructions / Assembly

ManualsBrandsDuluth Forge ManualsFireplace Logs22 in. Winter Oak Vent-Free Dual Fuel Gas Fireplace Log Set, 32,000 BTU, Thermostat Control

VENT

FREE GAS LOGS

INSTALLATION INSTRUCTIONS

MODELS

FVFLC22

LOG CLUSTER

For Use With FLM24

LP, FLM24

NG, FLT24

LP, FLT24

and FDLT24

1 Burner Chassis

Questions, problems, missing parts? Before returning to your retailer, call

our customer service department at 1-855-607-6557, 8:00 am - 4:30 pm CST,

Monday through Friday or email contact@factorybuysdirect.com

Summary of content (6 pages)

PAGE 1
VENT-FREE GAS LOGS INSTALLATION INSTRUCTIONS MODELS FVFLC22-1 LOG CLUSTER For Use With FLM24-1-LP, FLM24-1-NG, FLT24-1-LP, FLT24-1-NG and FDLT24-1 Burner Chassis Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-855-607-6557, 8:00 am - 4:30 pm CST, Monday through Friday or email contact@factorybuysdirect.
PAGE 2
TABLE OF CONTENTS Safety......................................................... 2 Local Codes............................................... 2 Qualified Installing Agency......................... 3 Installation Guidelines................................ 3 Installing Logs............................................ 4 Parts........................................................... 5 SAVE THIS BOOK INSTALLER: Leave this manual with the appliance. CONSUMER: Retain this manual for future reference.
PAGE 3
INSTALLATION GUIDELINES Qualified Installation Agency This set should only be installed by a qualified installation agency. Proper Log Placement Log placement is critical to proper burner performance. Logs must be correctly positioned onto the burner. The illustrations in this manual show the proper position for logs on this set. Owners need to be shown proper log placement and instructed not to move the logs. Logs must fit firmly onto the burner when positioned as shown in the illustrations.
PAGE 4
INSTALLING LOGS WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury. CAUTION: After installation and periodically thereafter, check to ensure that no yellow flame comes in contact with any log. With the heater set to High, check to see if yellow flames contact any log. If so, reposition logs according to the log installation instructions in this manual.
PAGE 5
INSTALLING LOGS 3. Place log #3 into the area between the front log bracket and grate fingers. 4. Place log #4 into notches in logs #1 and #3 at the left as shown. 5. Place log #5 into notches in logs #2 and #3 at the center as shown. 6. Place log #6 into notches in logs #1 and #3 as shown. The center of Log #6 will rest on a flat on log #2 IMPORTANT: When placing logs 4, 5 and 6 ensure logs are securly placed into cut out notches in logs 1, 2 and 3.
PAGE 6
Factory Buys Direct.com 2701 Industrial Drive Bowling Green, KY 42101 1-855-607-6557 20023502 Rev.