Use and Care Manual

www.factorybuysdirect.com
200373-01A18
INSTALLATION
Figure 18 - Installing Log #4
Figure 19 - Installing Log #5 and #6
Pin for Log #5
Log #5
Hole for Log #6
Log #6
Log #4
INSTALLING BATTERIES
CAUTION: Do not dispose of
batteries in re, batteries may
explode or leak.
• Batteries are included.
• Remove batteries when depleted.
• Be sure to observe proper polarity (+/-)
when installing or replacing the batteries.
Damage due to improper battery installa-
tion may void the warranty on the product.
• For long periods of non-operation, remove
batteries from all components for safety.
Unscrew ignitor cap and install a AAA battery
with the + pointing out. Replace cap.
Figure 20 - Installing Battery in Ignitor
AAA
Battery
Positive
UP
4. Install pins on log #4 onto the two slots
in the front bracket (see Figure 16 and
Figure 18).
5. Insert the recessed hole on the bottom of
log #5 onto the pin on log #2 (see Figures
18 and 19).
6. Insert the pin on log #6 into the hole on
log #3 (see Figures 18 and 19).
IMPORTANT: Make sure logs do not cover
any burner ports. It is very important to install
the logs exactly as instructed. Do not modify
logs. Use only logs supplied with heater.