Use and Care Manual

www.factorybuysdirect.com
3M180017-1
IMPORTANT INSTRUCTIONS CONT.
3. Extreme caution is necessary when any heater is used by or near children or
individuals and whenever the unit is left operating and unattended.
4. Always unplug the electric replace when not in use.
5. Do not operate any unit with a damaged electrical cord or plug, or if the heater
has malfunctioned, or if the electric replace has been dropped or damaged in
any manner. Return heater to authorized service facility for examination, electrical
or mechanical adjustment, or repair.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
NO USER-SERVICEABLE PARTS INSIDE
6. Do not use outdoors.
7. The electric replace is not intended for use in bathrooms, laundry areas and
similar indoor locations. Never locate heater where it may fall into a bathtub or
other water container.
8. Do not run the electrical cord under carpeting. Do not cover electrical cord with
throw rugs, runners, or similar materials. Arrange electrical cord away from trafc
area and where it will not be tripped over.
9. To disconnect the unit, turn the controls off, then remove the electrical plug
from the outlet.
10. Do not insert or allow foreign objects to enter any ventilation or exhaust open-
ing as this may cause an electric shock or re, or damage to the heater.
11. To prevent a possible re, do not block air intake or exhaust in any manner.
Do not use on soft surfaces, like a bed, where openings may become blocked.
12. All electrical heaters have hot and arching or sparking parts inside. Do not
use in areas where gasoline, paint, or ammable liquids are used or stored or
where the unit will be exposed to ammable vapors.
13. Do not modify the electric replace. Use it only as described in this manual.
Any other use not recommended by the manufacturer may cause re, electric
shock or injury to persons.
14. To reduce the risk of electric shock, this appliance has a polarized plug (one
blade is wider than the other). This plug will t in a polarized outlet only one way.
If the plug does not t fully in the outlet, reverse the plug. If it still does not t,
contact a qualied electrician to install the proper outlet. Do not change the plug in
any way. Avoid the use of an extension cord. Extension cords may overheat and