INSTRUCTION MANUAL FOR WINE COOLER MODEL NO. DX-45.158K DX-143.392K DX-154.396K Thanks for buying our wine cooler, wish our advanced product will take care of your wine very well and you can have joyful taste. Before use, please read and follow all safety rules and operating instructions.
SAFETY INSTRUCTIONS ATTENTION WARNING To reduce the risk of fire, electrical shock, or injury when using your appliance, follow these basic precautions: READ ALL INSTRUCTION BEFORE USING THE WINE COOLER. This appliance can be used for wine storage only! Don't let children operate the wine cooler or seek connections with any position of the cabinet, in case that the cabinet turnover and cause the bodily injury.
electric radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Avoid locating the unit in moist area. Plug the Wine Cooler into an exclusive, properly installed-grounded wall outlet. INSTALLION DRAWING In order to let your units working on good conditions, please make sure to keep sufficient air circulation for cabinet. Please strict accordingly to below installation drawing to well install your cabinet. Model DX-45.158K Model DX-143.
OPERATING YOUR WINE COOLER AND SETTING THE TEMPERATURE CONTROL Please use the cabinet under 5-35 ambient temperature, if the ambient temperature is higher than or lower than this temperature, it will cause the temperature fluctuation in the cabinet, maybe can't reach 5-18 . CONTROLL SYSTEM INSTRUCTION : DX-45.158K LIGHT Control the interior light ON/OFF RUN When it’s ON, the cooling system runs. Power control this appliance turn on/off.
display the actual temperature. DX-154.396K Light Control the interior light ON/OFF RUN When it’s ON, the cooling system runs. Power control this appliance turn on/off. ( press and hold this buttons for approximately 3 seconds); “Set Upper” BUTTER The temperature setting can be adjusted from 5 to 18 (41 to 65 ). When pressing this button, the system will be entering the set up mode in the upper compartment automatically. The LED will flashing and display the setting temperature.
DX-143.392K The controls of your Wine cooler ℃ Power Light (the upper zone and middle zone) ℃ RUN Set Upper Set Middle Upper Chamber Middle Chamber RUN Indicator light illuminates to signify the cooling mode is currently in operation. Light To control the inner light turn on/off. Power To control this appliance turn on/off. “Set Upper” Button To set the temperature of the upper chamber. “Set Middle” Button To set the temperature of the middle chamber.
C RUN UP DOWN DISPLAY “UP” Button Used to raise(warm) the temperature in 1 . “DOWN” Button Used to lower(cool) the temperature in 1 . “DISPLAY” To shows the temperature of the lower compartment. Setting the Temperature Control • • • • To set the temperature: Connect the power cord to a properly grounded outlet. In the event of a power interruption, all previous temperature settings are automatically erased and it will default to a preset temperature setting of: 7 .
USING ATTENTION Store wine in sealed bottles. Do not overload the cabinet. Do not open the door unless necessary Do not cover shelves with aluminum foil or any other shelf material, which may prevent air circulation. Should the wine cooler be stored without use for long periods it is suggested, cut off the power and careful cleaning, leave the door ajar to allow air to circulate inside the cabinet in order to avoid possible formations of condensation, moldy or odors.
ALL THE APPLIANCES ARE DESIGNED QITH LED LIGHE, IF LED LIGHT DAMAGE ,PLEASE CONTACT WITH AFTER-SALE SERVICE TO REPLACE IT. PROBLEMS WITH YOUR WINE COOLER You can solve many common Wine Cooler problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you solve the problem before calling the servicer.
