Instructions / Assembly
Table Of Contents
Step-1 PREPARING THE SURFACE
Wipe off the ceiling / surface and make it smooth and even.
Remove loose plaster, paint, wallpaper etc.
Step-2 DRAW AN ANGLE
Draw straight lines in the corner (in width and length part)
and make a 90 degree angle, for starting point of pasting.
Step-3 APPLY THE ADHESIVE
Step-4 PLACE AND PRESS:
Place the sheet into the required position
(first sheet at the 90-degree point) and press firmly, but gently.
Overlap the ends of the previous sheet using firm but gentle pressure again.
The advantage of the decorative ceiling system in 24" x 24" with overlapping
edges is that it provides you with an extra and unique edge for your PVC
ceiling panels decoration due to multiple designs available in all colors.
HOW TO INSTALL DROP IN CEILING TILES
INSTALLATION PROCESS
· You will not need to find the centre of the room when you are installing
drop-in ceiling tiles. This is because you can use the outlay of the
exisng le system as a guide. Simply install the first le by pushing the ends
into the creases of the exisng grid system. Take care not to push too hard on
the le, but just gently enough to insert it over the exisng le.
· Repeat the same process described in Step 1 until you have completed all of
the whole les and are le with the corners.
· The 'cut-to-fit' drop-in ceiling tiles may need an adhesive to hold them tightly in
place. This is because they will not be held from all four corners into
HOW TO INSTALL GLUE UP CEILING TILES
the existing grid system. However, if you are able to cut the tiles to ensure
tight fit between them and the walls, then you may not need an adhesive.