User's Manual

English

Switching the Player On and Off

To put the player into the standby mode, press the «POWER» RC button. To exit the standby mode, press this buttons

again.

Depending on the player settings (see the player setup menu), the «hardware standby» or «software standby» mode

    

                   

functioning. For example, if you have some storage devices connected to the player, you may still access them from

network («NAS» function of the player). Exiting the «software standby» mode takes just a few seconds. When the



in the «software standby» mode for a while if you do not need it.

To switch the player off completely, disconnect the power plug.

NOTE: #  ##           -! !0 !$  

!!'#

NAS (Network Attached Storage)

You can access storage devices connected to the player from the local network using FTP and SMB protocols. On a



address of the player.

Wi-Fi



local network via Wi-Fi.

Please see here for the information on supported USB Wi-Fi adapters: http://dune-hd.com/support/hw_compat/