User manual

15
Connection to a TV set with component video
signal input (Component Video, Y, Cb, Cr)
AUDIO IN
R L
COMPONENT
VIDEO IN
For this connection you should
use a 3RCA-3RCA video cable
and (optionally) a 2RCA-
2RCA audio cable for sound
transmission to your TV set.
Please note that video cable
shall have an impedance of
75 Ohm, i.e. specially fitted
for transmission of analog
video signal
AUDIO IN
R L
S VIDEO IN
Since both these kinds of
connection do not allow a high-
quality picture, we recommend
to use them only in case that
your TV or projection set
does not have modern video
interfaces, such as HDMI or
Component Y, Cb, Cr.
1
1
2
2
3
3
4
4
Connections
Make sure that the player and TV set are switched off. Do not switch on until the end
of connection procedure.
Connect the component video output of media player with relevant TV input using
a 3RCA-3RCA cable.
Optionally connect audio output AUDIO L R of the player with relevant input of TV
set using a 2RCA-2 RCA cable (note: you can use optical cable to transmit digital
audio to your A/V receiver; this way better audio quality result may be expected).
Using RC of TV or projector (depending on what you use), select required input and
display mode. For more instructions please refer to the manual of your displaying
equipment.
Connection to a TV set with composite video or
S-Video signal
Make sure that the player and TV set are switched off. Do not switch on until the end
of connection procedure.
Connect the media player with relevant TV input using a RCA-RCA or S-Video cable,
depending on equipment.
Optionally connect audio output AUDIO L R of the player with relevant input of TV set
using a 2RCA-2 RCA cable (note: you can use optical cable to transmit digital audio
to your A/V receiver; this way better audio quality result may be expected).
Using RC of TV or projector (depending on what you use), select required input and
display mode. For more instructions please refer to the manual of your displaying
equipment.
Chapter 4