User guide

ManualsBrandsDunkirk ManualsWater boilerQ95M-200 Modulating Condensing Boiler

WARNING

Install boiler so gas ignition system components

are protected from water (dripping, spraying,

rain, etc) during appliance operation and service

(circulator replacement, etc).

This addendum applies to series:

UB90, UB95, Q90, Q95M, K90, K95M, BW9 & GWB9, FW95M & OL95M

WARNING

You

MUST

follow these instructions to prevent

damage to boiler’s heat exchanger caused by

inadequate dielectric isolation, incorrect water

treatment or antifreeze application. Failure to

comply could result in possible severe personal

injury, death or substantial property damage.

Instructions in this addendum replace all related

information in Boiler Installation Manual, User’s

Manual, or any other supplemental instruction or

addendum.

Apply this information in place of any related

information in Installation, Operation &

Maintenance Manual Accompanying this boiler.

• DIELECTRIC ISOLATION

Two (2) 1-1/4” X 1-1/4” Female to female

dielectric isolation unions are shipped loose

in boiler parts bag. Install Dielectric Isolation

unions at boiler supply line and return line. Install

isolation ﬁ ttings nearest boiler prior to system

piping connections.

• WATER TREATMENT and ANTIFREEZE

PROTECTION

MUST

be applied for

ALL

aluminum series

high efﬁ ciency gas-ﬁ red boilers using antifreeze

protection.

P/N# 240006888, Rev. E [06/2011]

Aluminum Series

High Efﬁ ciency Gas-Fired Boiler

DIELECTRIC ISOLATION &

ANTIFREEZE PROTECTION

ADDENDUM

Summary of content (4 pages)

PAGE 1
Aluminum Series High Efficiency Gas-Fired Boiler DIELECTRIC ISOLATION & ANTIFREEZE PROTECTION ADDENDUM This addendum applies to series: UB90, UB95, Q90, Q95M, K90, K95M, BW9 & GWB9, FW95M & OL95M WARNING You MUST follow these instructions to prevent damage to boiler’s heat exchanger caused by inadequate dielectric isolation, incorrect water treatment or antifreeze application. Failure to comply could result in possible severe personal injury, death or substantial property damage.
PAGE 2
System and Operating Precautions Applies to ALL Aluminum High Efficiency Gas-Fired Water Boilers WARNING ! WARNING Clean the System First BEFORE connecting boiler to heating system, clean and flush system thoroughly. Verify system is free of sediment, flux and any residual boiler water additives. Eliminate System Leaks Continuous addition of make-up water will constantly add oxygen to system. Eliminate all system leaks. All system leaks must be repaired immediately.
PAGE 3
System and Operating Precautions Applies to ALL Aluminum High Efficiency Gas-Fired Water Boilers WARNING General Guidelines When Using Antifreeze • Use only antifreeze products recommended for use with aluminum boilers, as listed in this addendum. See Table 1. • If system has leaked, water and antifreeze chemistry will need to be adjusted. To avoid damage to boiler, check pH and chemistry of boiler solution and consult the antifreeze manufacturer for recommendations.
PAGE 4
System and Operating Precautions Applies to ALL Aluminum High Efficiency Gas-Fired Water Boilers Table 1 Antifreeze Products Compatible Aluminum Antifreeze & Inhibitor Suppliers Noburst AL Antifreeze Noble Company P. O. Box 350 Grand Haven, MI 49417 www.noblecompany.com Tel: 800-878-5788 Fax: 231-799-8850 Rhogard Antifreeze & Pro-Tek 922 Inhibitor* Rhomar Water Management, Inc. P. O. Box 229 Springfield, MO 65801 www.rhomarwater.