Instruction Manual

POWER
The Jerry Cantrell Signature Cry Baby
®
Wah Wah is powered by one 9-volt battery
(accessed via the bottom of the pedal),
an AC adapter such as the Dunlop ECB003/
ECB003E, or a DC Brick
™
power supply.
SETUP INSTRUCTIONS
•Runashieldedinstrumentcablefromyour
guitartotheJC95’sINSTRUMENTjack.
•Runanothershieldedinstrumentcable
fromtheJC95’sAMPLIFIERjackto
your amplifier input.
•Turnontheamplierandbeginplaying.
•Toturnthepedalon/off,pushthetoeof
the pedal down until you feel a “click.”
•RotatetheFINETUNEknobclockwisefora
brighter toe-down response or counterclock-
wise for a darker toe-down response.
SPECIFICATIONS
Impedance
Input 1MΩ
Output 10 kΩ
Filter Center Frequency
Heel Down 320 Hz to 390 Hz
Toe Down
 FineTuneMax 1700Hzto2070Hz
 FineTuneMin 1050kHzto1270Hz
Maximum Level
Input -11.5 dBV
Output +6 dBV
Maximum Gain at Center Frequency
Heel Down +18 dB
Toe Down +20 dB
Noise Floor
*
HeelDown >97dB
Toe Down >89 dB
Bypass Hardwire
Current Draw 1 mA
Power Supply 9 volts DC
*V
REF
=1V
RMS,
A-weighted
JC95 JERRY CANTRELL CRY BABY
®
WAH WAH