User Manual

JB95 JOE BONAMASSA CRY BABY
POWER
The JB95 Cry Baby
®
can be powered
by one 9 volt battery (accessed via the
bottom of the pedal), a Dunlop ECB003
AC adapter (ECB003E in Europe) or a
Dunlop DCB10 DC Brick power supply.
SETUP INSTRUCTIONS
• Runashieldedinstrumentcable
from your guitar to the Cry Baby’s
Instrument jack.
• Runanothershieldedinstrument
cable from the Cry Baby’s Amplifier
jack into your amplifier input.
• Turnontheamplierand
begin playing.
• Toturnthepedalon/off,push
the toe of the pedal down until
you feel a “click”.
• Byrockingyourfootbackand
forth on the pedal, you can change
the effect that the JB95 Cry Baby
has on the tone of your instrument
instantaneously.
•Internalswitch(shownindiagram)
enablesTRUEHARDWIREBYPASS.
SPECIFICATIONS
Impedance
Input 800 kΩ
Output 10 kΩ
Filter Parameter
LowPass 290Hz~310Hz
HighPass 1400kHz~1510kHz
Maximum Level
Input -8.0 dBV
Output +10 dBV
Maximum Gain
HeelDown
 +16.5dB@1400Hz~1510Hz
Toe Down
 +16.5dB@290Hz~310Hz
Current Draw 1.35 mA
Remove bottom plate to access internal
TRUE HARDWIRE BYPASS switch, illustrated
below in the factory preset “off” position.
OFF