JCT95 JUSTIN CHANCELLOR CRY BABY® WAH
EXTERNAL CONTROLS 1 2 3 4 5 FIGURE 1 6 7 8 9 10 11 1 W AH SELECT footswitch toggles between UK Filter (BLUE-lit controls) & Wah (YELLOW-lit controls) modes 7 TONE knob adjusts EQ of fuzz signal 2 WAH VOL knob sets overall volume of Wah mode 9 F UZZ SELECT footswitch toggles fuzz on/off (RED-lit controls indicate on) 3 W AH Q knob adjusts Wah mode’s bandpass shape from wide to narrow 8 V OL knob adjusts overall volume of fuzz signal 4 U .K. FILTER VOL knob sets overall volume of U.K.
BASIC OPERATION POWER The Justin Chancellor Cry Baby ® Wah is powered by one 9-volt battery (accessed via the bottom of the pedal), the Dunlop ECB003 9-volt adapter, or an MXR® Brick™ Series power supply. DIRECTIONS 1. Run an instrument cable from your instrument to the JCT95’s INSTRUMENT jack and another instrument cable from the JCT95’s AMPLIFIER jack into your amplifier’s input. 2. Start with all knobs set to 12 o’clock. 3. This pedal is bypassed (off) while your foot is off the rocker.
SPECIFICATIONS IMPEDANCE Input Impedance 1 MΩ Output Impedance 1 kΩ RESONANT FREQUENCY RANGE* Wah 340 Hz to 1920 Hz U.K Filter 232 Hz to 2700 Hz MAXIMUM LEVEL Input - Bypass, Fuzz, Wah, U.K Filter +12 dBV - 4 dBV Output - Bypass, Wah, U.K Filter +12 dBV Output- Fuzz + 2 dBV GAIN Wah Heel Down* +12.5 dB Wah Toe Down* +19 dB U.K. Filter Heel Down* +8 dB U.K.
SPECIFICATIONS NOISE FLOOR **** Bypass -98 dBV Wah Heel Down* -92 dBV Wah Toe Down* -78 dBV U.K. Filter Heel Down* -97 dBV U.K. Filter Toe Down* -91 dBV Fuzz ***** - 75 dBV BYPASS Automatic Buffered Delay Ring-Out Time 30ms to 560ms Power Supply 9 volts DC Current Draw 48 mA 0 dBV = 1VRMS *Fuzz Effect Off, Wah and U.
