Installation Guide

Sealing Round Pipes, and Other Round Objects, with Outside Diameters (OD) Less Than 2" (continued)
6. Fan out DuPont™ FlexWrap
™
EZ so it extends onto the
WRB
7. Cut a second piece of
FlexWrap
™
EZ the length of
the pipe circumference.
8. Fold the second piece of FlexWrap
™
EZ to break perforations in release paper and create
a sharp crease. Remove narrow (~1") width of release paper. While still folded, center
FlexWrap
™
EZ above the pipe and use the remaining release paper to position tight
against the WRB. Adhere the exposed butyl to the top, and down each side of the pipe to
the 3 and 9 o’clock positions.
9. Extend the length of
FlexWrap
™
EZ and gently
remove remaining release
paper to avoid stretching
the product.
10. Position the unadhered
butyl of the narrow section
below to overlap the edges
of FlexWrap
™
EZ installed
first by a minimum of 1".
Use thumbs to adhere. Do
not stretch FlexWrap
™
EZ.
11. Fan out the remaining unadhered FlexWrap
™
EZ onto the WRB above and down each
side of the pipe.
12. Use firm hand pressure on both pipe and WRB
surfaces for a good bond and secure seal. Remove
any wrinkles or creases by using firm hand pressure
to ensure a fully adhered and smooth surface.