Installation Guide

1. Measure and cut a 2" length
of DuPont
™
FlexWrap
™
EZ
NOTE: Larger wires, cables,
or bundles of wires may
require a longer piece of
FlexWrap
™
EZ.
2. Fold the piece of FlexWrap
™
EZ to break perforations in
release paper to create a 90
degree angle.
3. Remove narrow (~1") width
of release paper.
4. Position FlexWrap
™
EZ above
the wire so the exposed
butyl is centered on top of
the wire, and the side with
remaining release paper is
against the WRB.
5. Extend both sides of
FlexWrap
™
EZ below the
wire and adhere each
corner and outside edge to
WRB as shown.
6. Pinch together the exposed
butyl of FlexWrap
™
EZ below
wire to create a flap and
complete a full perimeter
seal around wire. Use firm
hand pressure to remove
any pinholes at the crease
below the wire where the
butyl is adhered together.
7. Remove remaining release
paper.