User Manual

V4.1M86
Flush The Filter
The Water Selector Switch is located on the far right end of the filter unit. Turn
the Water Selector Switch to the vertical position. Turn on the cold water tap and
allow water to run through the filter until the meter changes from “Flh” to “ooo”.
Do not drink or use the filtered water during the flush cycle.
If the numbers “888” appear on the Filter Life Meter then the viewing angle is
not correct. To read the display correctly the meter must be viewed at eye level.
This flush will remove any carbon particles and activate the filter for use. It is
normal to see some carbon particles rinsed from the filter during the initial flush.
The flush does not affect the cartridge life. The cartridge included with this
system is good for up to 200 gallons of water, and the gallons used are only
measured after the filter has been activated. Please refer to the Replacement
Cartridge section for expected life of your filter and contaminant reductions.
5
Step
Installation
Always view meter at eye level.
Water Temp < 100F/37.7C
Do Not Filter Hot Water