Manualshelf

Instructions / Assembly

ManualsBrandsDuPont ManualsKitchen1 Stage QuickTwist Undersink Water Filtration System
11121314151617181920
STEP 3
-Optional Direct Connect
Connect Water Lines
FOR RIGID TUBING:
1 Disconnect the bottom of the cold water plumbing line from the shut-off valve and gently bend the plumbing line for access to the
lower line fitting.
2 Screw the 3/8" Male OD Adaptor D onto the compression fitting on the lower end of the plumbing line.
3 Screw the 3/8" Female OD Adaptor E onto the cold water shut-off valve outlet port.
FOR FLEXIBLE TUBING:
1 Disconnect the bottom of the cold water plumbing line from the shut-off valve.
2 Screw the 3/8" Male OD Adaptor D onto the existing nut on the lower end of the flexible hose.
3 Screw the 3/8" Female OD Adaptor E onto the cold water shut-off valve outlet port.
STEP 4
-Optional Direct Connect
Connect the 1/4" Plastic Tubing
ROM SYSTEM HEAD INLET TO 3/8" FEMALE OD ADAPTOR:
1 Determine the length of 1/4" Plastic Tubing F that will be necessary to connect the System Head Inlet to the 3/8" Female OD
Adaptor at the shut-off valve. Make sure to allow enough 1/4" Plastic Tubing to prevent kinking in the line.
2 Cut the 1/4" Plastic Tubing squarely on both ends.
3 Wet one end of the 1/4" Plastic Tubing with water and push it into the System Head Inlet until it stops.
NOTE: Do not bend or crimp 1/4" Plastic Tubing when inserting.
4 Wet the other end of the 1/4" Plastic Tubing with water and push it into the 3/8" Female OD Adaptor until it stops.
NOTE: Do not bend or crimp 1/4" Plastic Tubing when inserting.
FROM SYSTEM HEAD OUTLET TO 3/8" MALE OD ADAPTOR:
5 Determine the length of 1/4" Plastic Tubing F that will be necessary to connect the System Head Outlet to the 3/8" Male OD Adaptor
on the lower end of the plumbing line. Make sure to allow enough 1/4" Plastic Tubing to prevent kinking in the line.
6 Cut the 1/4" Plastic Tubing squarely on both ends.
7 Wet one end of the 1/4" Plastic Tubing with water and push it into the System Head Outlet until it stops.
NOTE: Do not bend or crimp 1/4" Plastic Tubing when inserting.
8 Wet the other end of the 1/4" Plastic Tubing with water and push it into the 3/8" Male OD Adaptor until it stops.
NOTE: Do not bend or crimp 1/4" Plastic Tubing when inserting.
WFQT13000 & WFQT13500 Series
11
V4.0
3
1
RIGID
T
UBING
D
F
A
E
COLD WATER
V
ALVE
2
3
INLET OUTLET
F
F
E
D
7
8
INLET OUTLET
A
3
4
FLEX
TUBING