Instructions / Assembly

STEP 7
Install the QuickTwist
™
Filter
1 Hold the QuickTwist
™
Filter B with the label facing to the left slightly. The two nozzles on top of the QuickTwist
™
Filter should be
toward the back of the QuickTwist
™
Filter. If holding properly, the two extended flanges on top of the QuickTwist
™
Filter should be
out to each side. See Figure 6
1 at right.
2 Lift the QuickTwist
™
Filter straight up into the System Head A until the two nozzles seat into the ports and the two extended flanges
on top of the QuickTwist
™
Filter are fully engaged into the System Head.
3 Turn the QuickTwist
™
Filter counter-clockwise until it stops.
STEP 8
Test the Filter System for Proper Operation
1 Turn on the cold water shut-off valve under the sink.
2 Turn on the new Faucet for Filtered Water D. In order for the Filter System to flush out any air and carbon fines (fine black powder)
from the QuickTwist
™
Filter, allow the water to run for approximately 10 minutes.
3 Check for any leaks between the System Head assembly and Filter; around all fittings; on Kitchen Faucet Adapter H connection;
and on faucet/tubing connection.
If there are leaks between the System Head assembly and the QuickTwist
™
Filter:
n Turn off the cold water shut-off valve to the Filter System and turn on the Faucet for Filtered Water to drain the water and
release pressure.
n Remove the QuickTwist
™
Filter and inspect the O-Rings around the nozzles on top of it. Make sure they are in place and free
from dirt and particles.
n Turn off the Faucet for Filtered Water.
n Replace the QuickTwist
™
Filter by lifting it straight up into the System Head until the two nozzles seat into the ports and the
two extended flanges on top of the QuickTwist
™
Filter are fully engaged into the System Head. Turn the QuickTwist
™
Filter
counter-clockwise until it stops.
n Turn the cold water supply valve back on and turn on the Faucet for Filtered Water.
If there are leaks around the fittings:
n Turn off the cold water shut-off valve to the Filter System to release pressure in the System.
n While pulling the 1/4" Plastic Tubing
L with one hand, press in on the grey collar around the inlet and/or outlet fitting. Check
to make sure that the 1/4" Plastic Tubing is cut squarely and that it is not scratched. If the 1/4" Plastic Tubing is unevenly cut
or scratched, cut off 1/2" to 5/8" and re-install the Plastic Tubing (see Step 5 of Installation Instructions).
n Turn the cold water shut-off valve back on and turn on the Faucet for Filtered Water.
continued to next page
8
1
2
FLEXIBLE HOSE INSTALLATION
7
1
2
3
A
B
HOT WATER
VALVE
COLD WATER
VALVE
KITCHEN FAUCET
FAUCET FOR
FILTERED WATER
V4.0
8
WFQT13000 & WFQT13500 Series