Instructions / Assembly

WFRO60X-1
7
V4.4
STEP
Install RO Faucet (continued)
INSTALL REVERSE OSMOSIS FAUCET
Locate and organize your RO Faucet install parts. See packing list on page 1.
the sink surface. Position the toggle bolts to catch under the lower surface of the sink or counter, but ensure that they will not
the surface.
TIP: Make sure to keep the “wings” of the toggle bolts free to allow all tubing and faucet stem room
TIP: Instal
l the faucet base with the bolts at 5 & 11 o’clock positions to have the handle positioned at 90 degrees to the right
Ensure the RO Faucet Body Handle is positioned to your liking.
TIP: If there is not enough clearance for the tubing and the stem, the toggle wings may need to be adjusted to create more
clearance.
bolt screws firmly. Do not over-tighten.
6
1
2
3
4
5
6
7
8
RO Faucet Body to the RO Faucet Base yet. Then route the 3 tubes through the hole in the sink until 12” of
P Q
,
R
,
S
,
T
tubing remains above the sink. Lay RO Faucet Body on the counter top.
P
Route the 3 tubes , attached to the RO Faucet Body through the RO Faucet Base , but don’t connect the
R
,
S
,
T P QP
Mount Faucet Body to the sink hole by pushing the toggle bolts through the hole until the RO Faucet Body is flat against
P P
obstruct the faucet stem from sitting in place. Loosely tighten the toggle bolts until the RO Faucet Base is mounted loosely to
Q
Hold the RO Faucet Base firmly and mount the RO Faucet Body to the RO Faucet Base by turning 1/4 clockwise to lock.
Q Q
P
Turn the RO Faucet Body 1/4 turn counter-clockwise and remove the faucet enough to tighten the RO Faucet Base toggle
P Q
Mount the RO Faucet Body to the RO Faucet Base and turn 1/4 turn clockwise until it locks.
P Q
Mount the RO Faucet Spout to the RO Faucet Body by screwing spout nut to body.
PO
6
O
Mounting Surface
Q
P
1/4” Red Tube
3/8” White Tube
3/8” Red Tube
R
S
T
Attach to RO Faucet Body.
S